Toyota Tacoma (2015-2018) Service Manual: Transfer Case Front Oil Seal

Toyota Tacoma (2015-2018) Service Manual / Vf2cm Transfer / Transfer Case Front Oil Seal

Components

COMPONENTS

ILLUSTRATION

Replacement

REPLACEMENT

PROCEDURE

1. DRAIN TRANSFER OIL

2. SUPPORT TRANSMISSION ASSEMBLY

3. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY

4. REMOVE TRANSFER CASE LOWER PROTECTOR

5. REMOVE FRONT PROPELLER SHAFT ASSEMBLY

(See page 6. REMOVE OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY )

6. REMOVE OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY

7. REMOVE TRANSFER CASE OIL SEAL

(a) Using SST, remove the transfer case oil seal.

SST: 09950-40011

09951-04020

09952-04010

09953-04030

09954-04010

09955-04031

09957-04010

09958-04011

Text in Illustration

*a	Turn
*b	Hold

NOTICE:

Apply a lubricant to the threads and end of SST.

8. INSTALL TRANSFER CASE OIL SEAL

(a) Coat the lip of a new transfer case oil seal with MP grease.

(b) Using SST and a hammer, install the transfer case oil seal until its metal ring contacts the case.

SST: 09710-30041

09710-03221

SST: 09950-60010

09951-00600

09951-00650

09952-06010

SST: 09950-70010

09951-07150

9. INSTALL OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY

10. INSTALL FRONT PROPELLER SHAFT ASSEMBLY

(See page 11. INSTALL TRANSFER CASE LOWER PROTECTOR )

11. INSTALL TRANSFER CASE LOWER PROTECTOR

12. INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY

13. ADD TRANSFER OIL

14. INSPECT FOR TRANSFER OIL LEAK

Installation

INSTALLATION CAUTION / NOTICE / HINT CAUTION: Be sure to perform this procedure with several people as the transfer assembly is very heavy. PROCEDURE 1. INSTALL TRANSFER CASE LOWER PROTECTOR ( ...

Transfer Case Rear Oil Seal

Components COMPONENTS ILLUSTRATION Replacement REPLACEMENT PROCEDURE 1. DRAIN TRANSFER OIL 2. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY (See page ) 3. REMOVE OUTPUT SHAFT ...

Other materials:

Transmission Fluid Temperature Sensor "A" Circuit Low Input (P0712,P0713)
DESCRIPTION The No. 1 ATF temperature sensor converts the fluid temperature into a resistance value for use by the ECM. The ECM applies a voltage to the temperature sensor through terminal THO1 of the ECM. The sensor resistance changes with the ATF temperature. As the temperature becomes hi ...

Steering Angle Sensor Internal Circuit (C1433)
DESCRIPTION Steering angle sensor (spiral cable with sensor sub-assembly) signals are sent to the skid control ECU (master cylinder solenoid) via the CAN communication system. When there is a malfunction in the CAN communication system, it is detected by the steering angle sensor (spiral cabl ...

Tailgate
The tailgate can be opened. Pull the handle Open the tailgate slowly The support cables will hold the tailgate horizontal. After closing the tailgate, try pulling it toward you to make sure it is securely locked. Removing the tailgate ■ Before removing the tailgate (vehicles with r ...