CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
INSPECT BATTERY VOLTAGE |
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
|
3. |
CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
(a) Use the Techstream to check if the CAN communication system is functioning normally.
Result |
Proceed to |
---|---|
CAN DTC is not output |
A |
CAN DTC is output |
B |
B | ![]() |
GO TO CAN COMMUNICATION SYSTEM |
|
4. |
CHECK FOR DTC* |
(a) Clear the DTC.
Click here
(b) Recheck for DTC.
Click here
Result |
Proceed to |
---|---|
DTC is not output |
A |
DTC is output |
B |
B | ![]() |
GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
5. |
PROBLEM SYMPTOMS TABLE |
Result |
Proceed to |
---|---|
Fault is not listed in problem symptoms table |
A |
Fault is listed in problem symptoms table |
B |
B | ![]() |
GO TO STEP 7 |
|
6. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Operation Check.
Click here
(b) Terminals of ECU.
Click here
(c) DATA LIST / ACTIVE TEST.
Click here
|
7. |
ADJUST, REPAIR OR REPLACE |
|
8. |
CONFIRMATION TEST |
NEXT | ![]() |
END |
Inspection
INSPECTION
PROCEDURE
1. INSPECT WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
HINT:
The valve opening temperature is inscribed on the water inlet with thermostat
sub-assembly.
(a) Immerse the thermostat in the water, then heat the water gradually.
CAUTION:
Do not your hands into the wa ...
Heater Circuit (C1AAE)
DESCRIPTION
If the forward recognition camera detects a malfunction in the camera heater
(forward recognition hood) circuit, it will output a malfunction signal to the millimeter
wave radar sensor assembly via CAN communication and DTC C1AAE will be stored.
DTC No.
Detect ...
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the manual transaxle system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
...