Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

  • Use the following procedure to troubleshoot the manual transaxle system.

    *: Use the Techstream.

PROCEDURE

1.

VEHICLE BROUGHT TO WORKSHOP

NEXT

2.

CUSTOMER PROBLEM ANALYSIS

(a) Refer to the How to Troubleshoot ECU Controlled Systems in Introduction section.

Click here

NEXT

3.

INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard Voltage:

11 to 14 V

HINT:

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

NEXT

4.

CHECK CAN COMMUNICATION SYSTEM*

(a) Using the Techstream, check if the CAN communication system is functioning normally.

HINT:

  • Refer to CAN Bus Check in CAN Communication System.

    Click here

  • The ECM is connected to the CAN communication system. Therefore, before starting troubleshooting, make sure to check that there are no malfunctions in the CAN communications system.

Result

Proceed to

CAN communication system DTCs are not output.

A

CAN communication system DTCs are output.

B

B

GO TO CAN COMMUNICATION SYSTEM

A

5.

CHECK AND CLEAR DTCS AND FREEZE FRAME DATA*

(a) Refer to DTC Check/Clear.

Click here

NEXT

6.

SELECT CHECK MODE DIAGNOSIS*

(a) Refer to Check Mode Procedure.

Click here

NEXT

7.

CHECK FOR DTC*

(a) Proceed to DTC Check/Clear.

Click here

Result

Proceed to

DTCs are not output.

A

DTCs are output.

B

B

GO TO STEP 12

A

8.

SYMPTOM SIMULATION

(a) Refer to Symptom Simulation.

Click here

NEXT

9.

COMPONENT INSPECTION

NEXT

10.

REPAIR OR REPLACE

NEXT

11.

CONFIRMATION TEST

NEXT

END

12.

DIAGNOSTIC TROUBLE CODE CHART

(a) Proceed to Diagnostic Trouble Code Chart.

Click here

NEXT

13.

CIRCUIT INSPECTION*

NEXT

14.

IDENTIFICATION OF PROBLEM

NEXT

15.

REPAIR OR REPLACE

NEXT

16.

CONFIRMATION TEST

NEXT

END

Check For Intermittent Problems
CHECK FOR INTERMITTENT PROBLEMS HINT: Inspect the vehicle ECM using check mode. Intermittent problems are easier to detect with the Techstream when the ECM is in check mode. In check mode, the ECM ...

Problem Symptoms Table
PROBLEM SYMPTOMS TABLE Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of pro ...

Other materials:

Removal
REMOVAL PROCEDURE 1. REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System) Click here 2. REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Manual Air Conditioning System) Click here 3. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY Click here 4. REMOVE INSTR ...

AVC-LAN Circuit
DESCRIPTION Each unit of the navigation system connected to the AVC-LAN (communication bus) transfers the switch signals using the AVC-LAN. If a short to +B or short to ground occurs in the AVC-LAN, the navigation system will not function normally because communication is not possible. WIRING ...

Disposal
DISPOSAL CAUTION / NOTICE / HINT CAUTION: Before performing pre-disposal deployment of any SRS component, review and closely follow all applicable environmental and hazardous material regulations. Pre-disposal deployment may be considered hazardous material treatment. PROCEDURE 1. PRECAUTIO ...

В© 2011-2024 Copyright www.ttguide.net