Toyota Tacoma (2015-2018) Service Manual: How To Proceed With Troubleshooting
PROCEDURE
|
1. |
CHECK TIRE AND WHEEL SYSTEM |
| DIAGNOSIS OF IRREGULAR TIRE WEAR | .gif) |
GO TO STEP 11 |
|
.gif)
|
2. |
TIGHTEN WHEEL NUTS |
|
|
3. |
INSPECT TIRES |
Click here .gif)
| NG | |
GO TO STEP 8 |
|
|
4. |
INSPECT AND/OR ADJUST WHEEL BALANCE |
Click here
|
|
5. |
INSPECT FRONT AXLE HUB BEARING LOOSENESS AND AXLE HUB RUNOUT |
Click here
| NG | |
GO TO STEP 9 |
|
|
6. |
INSPECT REAR AXLE HUB BEARING LOOSENESS AND AXLE HUB RUNOUT |
Click here
| NG | |
GO TO STEP 10 |
|
|
7. |
PERFORM ROAD TEST |
| NEXT | |
RETURN VEHICLE TO CUSTOMER |
|
8. |
REPAIR OR REPLACE TIRE(S) |
| NEXT | |
GO TO STEP 4 |
|
9. |
REPAIR FRONT AXLE HUB BEARING LOOSENESS AND AXLE HUB RUNOUT |
Click here
| NEXT | |
GO TO STEP 6 |
|
10. |
REPAIR REAR AXLE HUB BEARING LOOSENESS AND AXLE HUB RUNOUT |
Click here
| NEXT | |
GO TO STEP 7 |
|
11. |
INSPECT TIRES |
Click here
| OK | |
GO TO STEP 13 |
|
|
12. |
REPAIR OR REPLACE TIRE(S) |
|
|
13. |
INSPECT AND/OR ADJUST FRONT WHEEL ALIGNMENT |
Click here
|
|
14. |
PERFORM ROAD TEST |
| NEXT | |
RETURN VEHICLE TO CUSTOMER |
Inspection
INSPECTION
PROCEDURE
1. INSPECT TIRES
(a) Check the tires for wear and proper inflation pressure.
Standard Cold Tire Inflation Pressure:
Tire Size
Front Wheel
kPa (kgf/c ...
Other materials:
VSC OFF Indicator Light does not Come ON
DESCRIPTION
Refer to VSC OFF Indicator Light Remains ON (See page
).
WIRING DIAGRAM
Refer to VSC OFF Indicator Light Remains ON (See page
).
CAUTION / NOTICE / HINT
NOTICE:
When replacing the skid control ECU (master cylinder solenoid), perform
calibration (See page
).
...
Towing Tail Relay
Inspection
INSPECTION
PROCEDURE
1. INSPECT TOWING TAIL RELAY
(a) Check the resistance.
(1) Using an ohmmeter, measure the resistance between the terminals.
Standard:
Tester Connection
Specified Condition
3-5
10 kΩ or higher
...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary
notices concerning the SRS airbag system before servicing (See page
).
HINT:
Use the same procedure for both the RH and LH sides.
The procedure des ...
