Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT VOLTAGE INVERTER ASSEMBLY
(a) Check the voltage inverter assembly.
(1) Measure the voltage according to the value(s) in the table below.
Text in Illustration
*a |
Component with harness connected (Voltage Inverter Assembly) |
- |
- |
Standard:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
V9-2 (B) - V9-1 (GND) |
Ignition switch (ON) |
11 to 15 V |
V9-1 (GND) - Body ground |
Always |
Below 1 V |
V8-5 (AC1) - V8-11 (AC2) |
Ignition switch (ON) Main switch (ON) |
108 to 132 V |
If the result is not as specified, replace the voltage inverter assembly.
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR CONSOLE BOX ASSEMBLY
(See page )
2. REMOVE VOLTAGE INVERTER ASSEMBLY
(a) Remove the bolt to disconnect the ground wire. |
|
(b) Disconnect the 2 connectors and disengage the clamp.
(c) Remove the 3 bolts and voltage inverter assembly. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL VOLTAGE INVERTER ASSEMBLY
(a) Temporarily install the voltage inverter assembly with the 3 bolts.
(b) Tighten the 2 bolts in the order shown in the illustration. Torque: 7.5 N·m {76 kgf·cm, 66 in·lbf} |
|
(c) Tighten the bolt. Torque: 15 N·m {153 kgf·cm, 11 ft·lbf} |
|
(d) Connect the 2 connectors and engage the clamp.
(e) Connect the ground wire with the bolt.
Torque:
8.0 N·m {82 kgf·cm, 71 in·lbf}
2. INSTALL REAR CONSOLE BOX ASSEMBLY
(See page )
System Description
SYSTEM DESCRIPTION
1. NAVIGATION SYSTEM OUTLINE
(a) Vehicle position tracking methods
It is essential that the navigation system correctly tracks the current vehicle
position and displays it on the map. There are 2 methods to track the current vehicle
position: autonomous (dead reckoning) and ...
Automatic Transmission Unit(for 2tr-fe)
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
...
High Power Supply Voltage Malfunction (C1417)
DESCRIPTION
If a malfunction is detected in the power supply circuit, the skid control ECU
(housed in the master cylinder solenoid) stores this DTC and the fail-safe function
prohibits ABS/VSC/TRAC operation.
This DTC is stored when the IG1 terminal voltage deviates from the DTC detection
co ...