Toyota Tacoma (2015-2018) Service Manual: How To Proceed With Troubleshooting

Toyota Tacoma (2015-2018) Service Manual / Differential / Differential System(w/ Rear Differential Lock) / How To Proceed With Troubleshooting

CAUTION / NOTICE / HINT

HINT:

Use the following procedure listed to troubleshoot the differential system (w/ Differential Lock).
*: Use the Techstream.

PROCEDURE

1.	VEHICLE BROUGHT TO WORKSHOP

2.	CUSTOMER PROBLEM ANALYSIS

3.	INSPECT BATTERY VOLTAGE

Standard voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

4.	CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

(a) Use the Techstream to check if the CAN communication system is functioning normally.

Click here

HINT:

The ECU of this system is connected to the CAN communication system.

Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN communication system.

Result	Proceed to
CAN DTCs are not output	A
CAN DTCs are output	B

CHECK CAN COMMUNICATION SYSTEM

5.	CHECK DTC AND FREEZE FRAME DATA*

(a) Check for DTCs.

Click here (b) Check for freeze frame data.

(b) Check for freeze frame data.

HINT:

Record or print DTCs and freeze frame data if necessary.

Click here (d) Recheck for DTCs.

(d) Recheck for DTCs.

Click here (1) Simulate the malfunction condition and check if the DTCs are output again.

(1) Simulate the malfunction condition and check if the DTCs are output again.

Result	Proceed to
DTCs are not output	A
DTCs are output	B

GO TO STEP 10

6.	PROBLEM SYMPTOMS TABLE

(a) Refer to Problem Symptoms Table.

Click here

Result	Proceed to
Fault not listed in problem symptoms table	A
Fault listed in problem symptoms table	B

GO TO STEP 8

7.	OVERALL ANALYSIS AND TROUBLESHOOTING*

(a) Terminals of ECU.

Click here (b) Data List / Active Test.

(b) Data List / Active Test.

Click here

8.	REPAIR OR REPLACE

9.	CONFIRM TEST

END

10.	GO TO DTC CHART

11.	REPAIR OR REPLACE

12.	CONFIRM TEST

END

System Diagram

SYSTEM DIAGRAM Transmitting ECU (Transmitter) Receiving ECU Signal Communication Method 4 wheel drive control ECU Skid cont ...

Problem Symptoms Table

PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are lis ...

Other materials:

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT FOR COOLANT LEAK HINT: The sliding surface inside the engine water pump assembly is lubricated by engine coolant. As some engine coolant is discharged during normal operation, engine coolant residue (solids) may be found on the drain plu ...

Operation Check
OPERATION CHECK INPUT SIGNAL CHECK *a +RES *b -SET *c ON-OFF *d CANCEL (a) Connect the Techstream to the DLC3. (b) Check the cruise control main switch using the Data List functio ...

Perchlorate Material
Special handling may apply, See www.dtsc.ca.gov/hazardouswaste/perchlorate. Your vehicle has components that may contain perchlorate. These components may include airbag, seat belt pretensioners, and wireless remote control batteries. CAUTION ■General precautions while driving Driving un ...