Toyota Tacoma (2015-2018) Service Manual: On-vehicle Inspection

Toyota Tacoma (2015-2018) Service Manual / 2gr-fks Cooling / Water Pump / On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT FOR COOLANT LEAK

HINT:

The sliding surface inside the engine water pump assembly is lubricated by engine coolant. As some engine coolant is discharged during normal operation, engine coolant residue (solids) may be found on the drain plug or the bottom of the engine water pump assembly. Also, engine coolant may leak if foreign matter enters the engine water pump assembly, however the sealing performance will recover when the foreign matter is pushed out or breaks into fine pieces. In this case, check the area around the engine water pump assembly.
Before performing this inspection, check that there are no engine coolant leaks from any parts other than the engine water pump assembly. If there are leaks, inspect those areas first.
Perform this inspection when the engine is cold.

(a) Visually check the engine water pump assembly.

(1) Check that engine coolant is not dripping from the engine water pump assembly.

HINT:

If engine coolant is dripping, replace the engine water pump assembly.
If engine coolant is not dripping, perform the following check.

(b) Inspect the area around the engine water pump assembly.

HINT:

Check for deposits around the drain plug of the engine water pump assembly.

(1) Remove the fan pulley (See page ).

(2) Press a piece of thin paper towel against the drain plug or deposits on the lip of the drain plug and check that the paper towel is not wet.

Text in Illustration

*a	Water Hole
*b	Air Hole

HINT:

If the thin paper towel is wet, replace the engine water pump assembly.
If the thin paper towel is dry, clean the area around the engine water pump assembly.

2. INSPECT ENGINE WATER PUMP ASSEMBLY

(a) Turn the pulley and check that the water pump bearing moves smoothly and quietly.

If necessary, replace the engine water pump assembly.

(b) Install the fan pulley (See page 3. INSPECT FLUID COUPLING ASSEMBLY ).

3. INSPECT FLUID COUPLING ASSEMBLY

(a) Remove the fan with fluid coupling assembly (See page ).

(b) Remove the 4 nuts and fan from the fluid coupling assembly.

If necessary, replace the fluid coupling assembly.

(d) Install the fan to the fluid coupling assembly with the 4 nuts.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

(e) Install the fan with fluid coupling assembly (See page Removal ).

Components

COMPONENTS ILLUSTRATION ILLUSTRATION ...

Removal

REMOVAL PROCEDURE 1. REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY (See page ) 2. REMOVE NO. 1 RADIATOR HOSE 3. REMOVE NO. 2 RADIATOR HOSE 4. DISCONNECT RADIATOR RESERVE TANK HOSE 5 ...

Other materials:

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for both the LH and RH sides. The procedure described below is for the LH side. PROCEDURE 1. INSTALL FOG LAMP ASSEMBLY (a) Engage the 2 guides to install the fog light assembly. (b) Install the screw. (c) Con ...

Panel Switches do not Function
PROCEDURE 1. CHECK PANEL SWITCH (a) Check for foreign matter around the switches that might prevent operation. OK: No foreign matter is found. NG REMOVE ANY FOREIGN MATTER FOUND OK ...

Diagnosis System
DIAGNOSIS SYSTEM DIAGNOSIS FUNCTION (a) The diagnosis function turns off the cruise control indicator, illuminates the master warning light and displays a warning message when a malfunction is detected. When a malfunction is detected in the dynamic radar cruise control system, DTCs are store ...