Toyota Tacoma manuals

Toyota Tacoma (2005–2015) Owners Manual: Perchlorate Material

Special handling may apply, See www.dtsc.ca.gov/hazardouswaste/perchlorate.

Your vehicle has components that may contain perchlorate. These components may include airbag, seat belt pretensioners, and wireless remote control batteries.

CAUTION

■General precautions while driving

Driving under the influence: Never drive your vehicle when under the influence of alcohol or drugs that have impaired your ability to operate your vehicle.

Alcohol and certain drugs delay reaction time, impair judgment and reduce coordination, which could lead to an accident that could result in death or serious injury.

Defensive driving: Always drive defensively. Anticipate mistakes that other drivers or pedestrians might make and be ready to avoid accidents.

Driver distraction: Always give your full attention to driving. Anything that distracts the driver, such as adjusting controls, talking on a cellular phone or reading can result in a collision with resulting death or serious injury to you, your occupants or others.

■General precaution regarding children’s safety

Never leave children unattended in the vehicle, and never allow children to have or use the key.

Children may be able to start the vehicle or shift the vehicle into neutral.

There is also a danger that children may injure themselves by playing with the windows, or other features of the vehicle. In addition, heat build-up or extremely cold temperatures inside the vehicle can be fatal to children.

Scrapping of your Toyota
The SRS airbag and seat belt pretensioner devices in your Toyota contain explosive chemicals. If the vehicle is scrapped with the airbags and seat belt pretensioners left as they are, this may cau ...

Symbols used throughout this manual
...

Other materials:

Combination Meter
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable fro ...

Personal Light Assembly
Components COMPONENTS ILLUSTRATION Installation INSTALLATION PROCEDURE 1. INSTALL MAP LIGHT BULB (a) Install the 2 map light bulbs to the 2 map light sockets. (b) Turn the 2 map light sockets with 2 map light bulbs in the direction indicated by the arrow shown in the ill ...

Disassembly
DISASSEMBLY PROCEDURE 1. INSPECT FRONT PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING (a) Check the spider bearings for wear and damage. (b) Check each spider bearing's axial play by turning the yoke while holding the shaft tightly. Maximum bearing axial play: 0 to 0.05 mm (0 to 0.002 i ...

© 2011-2026 Copyright www.ttguide.net