DESCRIPTION
The forward recognition camera receives necessary information from the millimeter wave radar sensor assembly.
When the forward recognition camera judges that a millimeter wave radar sensor assembly which is not compatible with the vehicle has been installed, DTC C1A0A is stored.
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
---|---|---|---|
C1A0A |
Front Radar Sensor Region Code Mismatch |
After the ignition switch is turned to ON for 3 seconds or more, the forward recognition camera detects that a millimeter wave radar sensor assembly which is not compatible with the vehicle is installed for 5 seconds or more. |
|
CAUTION / NOTICE / HINT
NOTICE:
Click here
Click here
PROCEDURE
1. |
CHECK FOR DTCs (FORWARD RECOGNITION CAMERA SYSTEM) |
(a) Clear the DTCs.
Click here
(b) Make sure that the DTC detection conditions are met.
HINT:
If the conditions are not met, the system cannot detect the malfunction.
(c) Check for DTCs.
Click here
Result |
Proceed to |
---|---|
DTC C1A0A is not output |
A |
DTC C1A0A is output |
B |
A |
USE SIMULATION METHOD TO CHECK |
|
2. |
REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY |
(a) Replace the millimeter wave radar sensor assembly.
Click here
(b) Adjust the millimeter wave radar sensor assembly.
Click here
|
3. |
CHECK FOR DTCs (FORWARD RECOGNITION CAMERA SYSTEM) |
(a) Clear the DTCs.
Click here
(b) Make sure that the DTC detection conditions are met.
HINT:
If the conditions are not met, the system cannot detect the malfunction.
(c) Check for DTCs.
Click here
Result |
Proceed to |
---|---|
DTC C1A0A is not output |
A |
DTC C1A0A is output |
B |
A |
END (MILLIMETER WAVE RADAR SENSOR ASSEMBLY WAS DEFECTIVE) |
B |
REPLACE FORWARD RECOGNITION CAMERA |
Master Cylinder Pressure Sensor Output Malfunction (Test Mode DTC) (C1281,...,C1458)
DESCRIPTION
DTC Code
DTC Detection Condition
Trouble Area
C1281
Stored only during test mode.
Master cylinder pressure sensor circuit
Skid control ECU, master cylinder pressure sensor (master cylinder
s ...
Tire Pressure Warning Light Circuit
DESCRIPTION
If the tire pressure warning ECU and receiver detects any problems, the tire
pressure warning light blinks for 1 minute then illuminates, and tire pressure monitoring
is disabled at the same time. At this time, the ECU stores a DTC in memory.
Connecting terminals TC and CG of the D ...
Disassembly
DISASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for both the LH and RH sides.
The procedure described below is for the LH side.
PROCEDURE
1. REMOVE NO. 1 HEADLIGHT BULB
(a) Turn the No. 1 headlight bulb in the direction indicated by the arrow
i ...