FREEZE FRAME DATA
DESCRIPTION
(a) Whenever a lane departure alert system is stored, the forward recognition camera stores the current vehicle state (ECU and sensor information) as Freeze Frame Data.
CHECK FREEZE FRAME DATA
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / LKA/LDA / Trouble Codes.
(e) According to the Techstream display, select a DTC that stored freeze frame data.
(f) Read the freeze frame data recorded when the DTC was stored.
Tester Display |
Measurement Item |
Range |
Normal Condition |
Diagnostic Note |
---|---|---|---|---|
Load System |
Type of system vehicle is equipped with/ LDA or LKA |
LDA or LKA |
LDA: Equipped with lane departure alert system |
LKA: Equipped with lane keeping assist system |
LDA Control |
Control status of lane departure alert system |
Prohibit or Permit |
Prohibit: Control prohibited Permit: Control permitted |
- |
Turn Signal Switch (Right) |
Turn signal switch (right) status |
OFF or ON |
ON: Turn signal light switch on (right) OFF: Turn signal light switch off |
- |
Turn Signal Switch (Left) |
Turn signal switch (left) status |
OFF or ON |
ON: Turn signal light switch on (left) OFF: Turn signal light switch off |
- |
Skid Control Buzzer Demand |
Lane departure alert buzzer demand status |
OFF or ON |
ON: Lane departure alert buzzer operating OFF: Lane departure alert buzzer not operating |
- |
Vehicle Information (2WD/4WD) |
Vehicle information (drivetrain) stored in forward recognition camera |
2WD, 4WD or Unknown |
2WD: for 2WD 4WD: for 4WD |
Unknown: Vehicle information not confirmed |
Vehicle Information (Conv/HV) |
Vehicle information (conventional/hybrid) stored in forward recognition camera |
Conv, HV or Unknown |
Conv: Conventional |
HV: Hybrid vehicle Unknown: Vehicle information not confirmed |
The Number of DTCs |
Number of stored DTCs |
min.: 0, max.: 255 |
Number of stored DTCs |
- |
Removal
REMOVAL
PROCEDURE
1. REMOVE MANUAL TRANSMISSION ASSEMBLY
(See page )
2. REMOVE CLUTCH RELEASE FORK SUB-ASSEMBLY
(a) Remove the clutch release fork sub-assembly with the clutch release
bearing assembly from the manual transmission assembly.
...
Rear Door Courtesy Switch
Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR DOOR COURTESY SWITCH
(a) Check the resistance.
(1) Measure the resistance using an ohmmeter, and check the results in accordance
with the value( s) in the table below.
Standard:
Tester Connection
Condition
S ...
AUTO LSD system
The AUTO LSD system aids traction by using the traction control system to control
engine performance and braking when one of the rear wheels begins to spin.
The system should be used only when one of the rear wheels spinning occurs in
a ditch or rough surface.
■ System operation
The sys ...