REMOVAL
PROCEDURE
1. REMOVE MANUAL TRANSMISSION ASSEMBLY
(See page )
2. REMOVE CLUTCH RELEASE FORK SUB-ASSEMBLY
(a) Remove the clutch release fork sub-assembly with the clutch release bearing assembly from the manual transmission assembly. |
|
(b) Remove the release fork support from the manual transmission assembly.
(c) Remove the clip and clutch release bearing assembly from the clutch release fork sub-assembly. |
|
(d) Remove the clutch release fork collar from the clutch release fork sub-assembly.
(e) Remove the clutch release fork dust seal from the clutch release fork sub-assembly.
3. REMOVE CLUTCH COVER ASSEMBLY
(a) Put matchmarks on the clutch cover assembly and flywheel sub-assembly. Text in Illustration
|
|
(b) Loosen each bolt one turn at a time until spring tension is released.
(c) Remove the 6 bolts and pull off the clutch cover assembly.
NOTICE:
Do not drop the clutch disc assembly.
4. REMOVE CLUTCH DISC ASSEMBLY
NOTICE:
Keep the lining part of the clutch disc assembly, the pressure plate and the surface of the flywheel sub-assembly away from oil and foreign matter.
Front Left Seat Heat Sensor Circuit (B14C1)
DESCRIPTION
Output to the front seat cushion heater assembly LH temperature sensor stops
if one of the following occurs: 1) the temperature sensor is open or shorted; or
2) the temperature sensor is damaged and its output value does not change.
DTC Code
DTC Detection Cond ...
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
If a DTC is displayed during the DTC check, check the circuit listed for the
DTC in the table below (refer to the appropriate page).
HINT:
When the SRS warning light remains on and the normal system code is
output, a decrease in the source voltage is li ...
Diagnosis System
DIAGNOSIS SYSTEM
CHECK DLC3
(a) Check the DLC3.
Click here
FUNCTION OF WARNING INDICATOR AND MESSAGE
(a) If the pre-collision system is not functioning properly, the driver is warned
by the PCS warning light and a warning message displayed on the multi-information
display.
Mas ...