DATA LIST / ACTIVE TEST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
DATA LIST
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Central Gateway / Data List.
(e) According to the display on the Techstream, read the Data List.
Tester Display |
Measurement Item |
Range |
Normal Condition |
---|---|---|---|
IG2 SW |
Ignition switch ON signal (IG2 terminal) |
OFF or ON |
OFF: Ignition switch ACC or off ON: Ignition switch ON |
IG1 SW |
Ignition switch ON signal (IG1 terminal) |
OFF or ON |
OFF: Ignition switch ACC or off ON: Ignition switch ON |
ACC SW |
Ignition switch ACC signal (ACC terminal) |
OFF or ON |
OFF: Ignition switch off ON: Ignition switch ACC or ON |
+B Voltage |
Battery voltage (BATT terminal) |
Over 8 V or Under 8 V |
Over 8 V: Battery voltage 8 V or higher Under 8 V: Battery voltage below 8 V |
Number of DTC |
Number of DTCs |
0 to 255 |
0: Normal |
Tire information
Typical tire symbols
1. Tire size
2. DOT and Tire Identification Number (TIN)
3. Location of treadwear indicators
4. Tire ply composition and materials
Plies are layers of rubber-coated parallel cords. Cords are the strands which
form the plies in a tire.
5. Uniform tire quality grading
F ...
Check Bus 3 Line for Short to GND
DESCRIPTION
There may be a short circuit between one of the CAN bus lines and GND when there
is no resistance between terminal 6 (CA3H) of the central gateway ECU (network gateway
ECU) and terminal 4 (CG) of the DLC3, or terminal 21 (CA3L) of the central gateway
ECU (network gateway ECU) and ...
Floor mat
Use only floor mats designed specifically for vehicles of the same model and
model year as your vehicle. Fix them securely in place onto the carpet.
Insert the retaining hooks (clips) into the floor mat eyelets.
Turn the upper knob of each retaining hook (clip) to secure the floor mats in
...