Toyota Tacoma (2015-2018) Service Manual: Can Communication System
- Parts Location
- Precaution
- System Diagram
- Problem Symptoms Table
- System Description
- Utility
- Dtc Combination Table
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Dtc Check / Clear
- Fail-safe Chart
- ECU Malfunction (B1003)
- Clearance Warning ECU Communication Stop Mode
- Air Conditioning Amplifier Communication Stop Mode
- ECM Communication Stop Mode
- Main Body ECU Communication Stop Mode
- Steering Angle Sensor Communication Stop Mode
- Center Airbag Sensor Communication Stop Mode
- Certification ECU Communication Stop Mode
- Combination Meter ECU Communication Stop Mode
- 4WD Control ECU Communication Stop Mode
- Blind Spot Monitor Sensor Communication Stop Mode
- Radio Receiver Assembly Communication Stop Mode
- Central Gateway ECU Communication Stop Mode
- Millimeter Wave Radar Sensor Communication Stop Mode
- Navigation Receiver Assembly Communication Stop Mode
- Open in Bus 2 Main Bus Line
- Check Bus 2 Line for Short to +B
- Check Bus 2 Lines for Short Circuit
- Open in Bus 3 Main Bus Line
- Open in One Side of Bus 2 Branch Line
- Check Bus 3 Line for Short to +B
- Check Bus 3 Lines for Short Circuit
- Check Bus 3 Line for Short to GND
- Open in Bus 5 Main Bus Line
- Open in One Side of Bus 3 Branch Line
- Check Bus 5 Lines for Short Circuit
- Check Bus 5 Line for Short to +B
- Check Bus 5 Line for Short to GND
- Open in One Side of Bus 5 Branch Line
- Front Camera Module Communication Stop Mode
- Tire Pressure Monitor ECU Communication Stop Mode
Parts Location
PARTS LOCATION
ILLUSTRATION
*A
for Hydraulic Brake Booster
*B
for Vacuum Brake Booster
*C
w/ Toyota Safety Sense P
...
Other materials:
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for Vehicle not Involved
in Collision)
(a) Perform a diagnostic system check (See page
).
(b) With the lower No. 1 instrument panel airbag assembly ...
Noise Occurs
PROCEDURE
1.
NOISE CONDITION
(a) Check from which direction the noise comes (front left or right, or rear
left or right).
OK:
The location of the noise source can be determined.
NG
GO TO STEP 3
OK
...
Dtc Check / Clear
DTC CHECK / CLEAR
1. DTC CHECK
HINT:
When DTC B1650/23 is detected as a result of troubleshooting for the
airbag system, troubleshoot the occupant classification system.
Use the Techstream to read and clear DTCs, otherwise the DTCs cannot
be read and cleared.
(a) Check ...
