Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART

Central Gateway ECU (Network Gateway ECU)

DTC Code

Detection Item

See page

B1003

ECU Malfunction

Data List / Active Test
DATA LIST / ACTIVE TEST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether ...

Dtc Check / Clear
DTC CHECK / CLEAR CHECK FOR DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Central Ga ...

Other materials:

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for both the LH and RH sides. The procedure described below is for the LH side. PROCEDURE 1. REMOVE NO. 1 FRONT WHEEL OPENING EXTENSION PAD (w/ Front Spoiler) 2. SEPARATE FRONT FENDER LINER (a) Remov ...

Manual transmission
■ Shifting the shift lever 6-speed models Fully depress the clutch pedal before operating the shift lever, and then release it slowly. 5-speed models Fully depress the clutch pedal before operating the shift lever, and then release it slowly. ■Maximum allowable speed Obse ...

Installation
INSTALLATION PROCEDURE 1. INSTALL OCCUPANT DETECTION ECU (a) Check that the ignition switch is OFF. (b) Check that the cable is disconnected from the battery negative (-) terminal is disconnected. CAUTION: After removing the cable from the terminal, wait for at least 90 seconds before star ...

В© 2011-2024 Copyright www.ttguide.net