DESCRIPTION
The ECM illuminates the cruise control SET indicator by sending indicator output demand signals to the combination meter assembly via CAN communication. The cruise control SET indicator illuminates when the dynamic radar cruise control system is controlling vehicle speed. The cruise SET indicator light circuit uses CAN communication. If the cruise control SET indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.
CAUTION / NOTICE / HINT
CAUTION:
Observe the following items for safety reasons when using Techstream:
NOTICE:
w/o Smart Key System: Click here
w/ Smart Key System: Click here
PROCEDURE
1. |
PERFORM ACTIVE TEST USING TECHSTREAM (METER DISPLAY 1) |
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Combination Meter / Active Test.
(e) Perform the Active Test according to the display on the Techstream.
Body Electrical > Combination Meter > Active Test
Tester Display |
Measurement Item |
Control Range |
Diagnostic Note |
---|---|---|---|
Meter Display 1 |
Multi-information display |
OFF, 6 to 0 or All |
- |
Result |
Proceed to |
---|---|
The multi-information display in the combination meter assembly turns on or off according to the operation of the Active Test. |
A |
The multi-information display in the combination meter assembly does not turn on or off according to the operation of the Active Test. |
B |
B |
GO TO METER / GAUGE SYSTEM |
|
2. |
READ VALUE USING TECHSTREAM (-SET SWITCH) |
(a) Turn the cruise control system on using the cruise control main switch (ON-OFF button).
(b) Drive at a speed between approximately 40 km/h (25 mph) and 180 km/h (110 mph).
(c) Enter the following menus: Powertrain / Radar Cruise1 / Data List.
(d) Read the Data List according to the display on the Techstream.
Powertrain > Radar Cruise1 > Data List
Tester Display |
Measurement Item |
Range |
Normal Condition |
Diagnostic Note |
---|---|---|---|---|
-SET Switch |
-SET switch status |
ON or OFF |
ON: -SET switch on OFF: -SET switch off |
- |
Result |
Proceed to |
---|---|
The cruise control SET indicator illuminates and turns off according to the operation of the cruise control main switch (-SET switch). |
A |
The cruise control SET indicator does not illuminate but the Data List item -SET Switch changes according to the operation of the cruise control main switch (-SET switch). |
B |
The cruise control SET indicator does not illuminate and the Data List item -SET Switch does not change according to the operation of the cruise control main switch (-SET switch). |
C |
A |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
B |
REPLACE COMBINATION METER ASSEMBLY |
C |
REPLACE ECM |
Operation Check
OPERATION CHECK
1. CHECK PANEL & STEERING SWITCH
HINT:
The radio and display receiver assembly panel switches and steering
switches are checked in the following procedure.
Illustrations may differ from the actual vehicle screen depending on
the device settings and options. ...
Radar Cruise Control Presence Determination Malfunction (Engine / HV) (C1A52)
DESCRIPTION
DTC C1A52 is stored when the ECM cannot recognize the millimeter wave radar sensor
assembly.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C1A52
Radar Cruise Control Presence Determination Malfuncti ...
Vanity Light
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedures for the LH and RH side.
The procedures listed below are for the LH side.
PROCEDURE
1. REMOVE VISOR ASSEMBLY
(a) Disengage the guide to separate the vi ...