Toyota Tacoma (2015-2018) Service Manual: Voice Guidance does not Function
PROCEDURE
|
1. |
CHECK VOICE GUIDANCE SETTING |
(a) Check that the voice guidance setting is not off.
OK:
Voice guidance setting is not off.
| NG | .gif) |
CHANGE THE VOICE GUIDANCE SETTING TO ON |
|
.gif)
|
2. |
CHECK AUDIO FUNCTION |
(a) Check that sound can be heard from a front speaker.
OK:
Sound can be heard.
| OK | |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
| NG | |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Poor Sound Quality in All Modes (Low Volume)
PROCEDURE
1.
CHECK AUDIO SETTINGS
(a) Set Treble, Mid and Bass to the initial values and check that sound is normal.
OK:
Malfunction disappears.
HINT:
Sound qual ...
Voice is not Recognized
PROCEDURE
1.
CHECK CONDITION
(a) Check if the system voice recognition level is low for a particular voice.
Result
Result
Proceed to
...
Other materials:
Installation
INSTALLATION
PROCEDURE
1. INSTALL HEADLIGHT DIMMER SWITCH ASSEMBLY
(a) Engage the 3 claws to install the headlight dimmer switch assembly.
(b) Connect the connector.
2. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY
3. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
(See page ) ...
Drive Belt
Components
COMPONENTS
ILLUSTRATION
Precaution
PRECAUTION
NOTICE:
Do not apply or add oil or grease to the belt tensioner to prevent abnormal
noises from the belt tensioner pulley, belt squealing, etc.
Do not allow oil or grease to adhere to the moving parts of the belt
...
Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR AXLE SHAFT
(a) Using a dial indicator, measure the runout of the shaft and flange.
Maximum runout:
Shaft runout: 1.5 mm (0.0591 in.)
Flange runout: 0.05 mm (0.0020 in.)
If the rear axle shaft or flange is damaged or worn, or the runout is greater
than ...
