Toyota Tacoma 2015-2018 Service Manual: Poor Sound Quality in All Modes (Low Volume)
PROCEDURE
|
1. |
CHECK AUDIO SETTINGS |
(a) Set Treble, Mid and Bass to the initial values and check that sound is normal.
OK:
Malfunction disappears.
HINT:
Sound quality adjustment measures vary according to the type of amplifier.
| OK | .gif) |
END |
|
.gif)
|
2. |
COMPARE WITH ANOTHER VEHICLE OF SAME MODEL |
(a) Compare with another vehicle of the same model which does not have trouble to see if there is any difference in the sound quality.
OK:
No difference is found.
| OK | |
END |
| NG | |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Screen Flicker or Color Distortion
PROCEDURE
1.
CHECK DISPLAY SETTING
(a) Reset display settings (contrast, brightness) and check that the screen appears
normal.
OK:
The display returns to normal. ...
Voice Guidance does not Function
PROCEDURE
1.
CHECK VOICE GUIDANCE SETTING
(a) Check that the voice guidance setting is not off.
OK:
Voice guidance setting is not off.
NG
CHANG ...
Other materials:
XM Tuner Antenna Disconnected (B15FE,B15FF)
DESCRIPTION
These DTCs are stored when a malfunction occurs in the antenna assembly with
holder which is connected to the navigation receiver assembly assembly.
DTC No.
DTC Detection Condition
Trouble Area
B15FE
The antenna assembly wi ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT TIE ROD END SUB-ASSEMBLY
(a) Flip the ball joint stud back and forth 5 times as shown in the illustration
before installing the nut.
(b) Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds
per turn and check the torque reading on the ...
Rear Occupant Classification Sensor LH Collision Detection (B1787)
DESCRIPTION
DTC B1787 is set when the occupant detection ECU receives a collision detection
signal, which is sent by the occupant classification sensor rear LH when an accident
occurs.
DTC B1787 is also set when the front seat with adjuster frame assembly RH is
subjected to a strong impact, ...
