TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Park Assist / Monitoring / Blind Spot Monitor System / Vehicle Speed Sensor (C1A45)

Toyota Tacoma (2015-2018) Service Manual: Vehicle Speed Sensor (C1A45)

DESCRIPTION

The blind spot monitor sensor receives vehicle speed signals from the skid control ECU (brake actuator assembly) via CAN communication.

DTC Code

DTC Detection Condition

Trouble Area

C1A45

A fail flag is transmitted from the skid control ECU (brake actuator assembly).
  • Vehicle stability control system
  • Blind spot monitor sensor LH
  • Blind spot monitor sensor RH

CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.

PROCEDURE

1.

CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM)

(a) Check for vehicle stability control system DTCs.

  • for Hydraulic Brake Booster (See page for Vacuum Brake Booster (See page for Vacuum Brake Booster (See page )
  • for Vacuum Brake Booster (See page ) )

OK:

Vehicle stability control system DTCs are not output.

Result

Result

Proceed to

OK

A

NG (for Hydraulic Brake Booster)

B

NG (for Vacuum Brake Booster)

C
B

GO TO VEHICLE STABILITY CONTROL SYSTEM

C

GO TO VEHICLE STABILITY CONTROL SYSTEM

A

2.

CHECK DTC

(a) Clear the DTCs (See page (b) Recheck for DTCs and check if the same DTC is output again (See page ).

(b) Recheck for DTCs and check if the same DTC is output again (See page Result ).

Result

Result

Proceed to

No DTC is output

A

DTC is output from the blind spot monitor sensor LH (master)

B

DTC is output from the blind spot monitor sensor RH (slave)

C
A

USE SIMULATION METHOD TO CHECK

B

REPLACE BLIND SPOT MONITOR SENSOR LH

C

REPLACE BLIND SPOT MONITOR SENSOR RH

    Related Tacoma materials

    Installation
    INSTALLATION PROCEDURE 1. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH (a) Install a new gasket to the cylinder head LH. NOTICE: Be careful of the installation direction. (b) Temporarily install the exhaust manifold sub-assembly LH with the 4 nuts. (c) Tighten the 4 nuts in the sequenc ...

    Installation
    INSTALLATION CAUTION / NOTICE / HINT CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page ). PROCEDURE 1. INSTALL SIDE AIRBAG SENSOR ASSEMBLY (a) Confirm that the ignition switch i ...

    Data List / Active Test
    DATA LIST / ACTIVE TEST 1. DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows t ...