Toyota Tacoma (2015-2018) Service Manual: SD Card Communication Malfunction (B158C)
DESCRIPTION
The navigation receiver assembly stores this DTC when the SD card cannot be mounted when inserted into the SD card slot.
|
DTC Code |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
B158C |
The SD card cannot be mounted when inserted into the SD card slot. |
|
PROCEDURE
|
1. |
CHECK SD CARD |
(a) Turn the ignition switch off and remove the SD card from the SD card slot.
(b) Check that the SD card is not damaged.
OK:
The SD card is not damaged.
| NG | .gif) |
REPLACE SD CARD |
|
.gif)
|
2. |
CLEAN COMPONENTS |
(a) Check that the terminals of the SD card are free of foreign matter. Remove foreign matter as necessary.
(b) Check that the SD card slot of the navigation receiver assembly is free of foreign matter. Remove foreign matter as necessary.
(c) Insert the SD card into the SD card slot.
|
|
3. |
CHECK DTC |
(a) Clear the DTCs (See page .gif)
).
(b) Recheck for DTCs and check that no DTCs are output (See page
).
OK:
No DTCs are output.
| OK | |
END (FOREIGN MATTER IS ADHERED TO SD CARD OR SD CARD SLOT) |
|
|
4. |
REPLACE SD CARD |
(a) Replace the SD card.
(b) Clear the DTCs (See page ).
(c) Recheck for DTCs and check that no DTCs are output (See page
).
OK:
No DTCs are output.
| OK | |
END (SD CARD WAS DEFECTIVE) |
| NG | |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
USB Media Malfunction (B1585)
DESCRIPTION
This DTC is stored when a malfunction occurs in a connected device.
DTC No.
DTC Detection Condition
Trouble Area
B1585
USB De ...
AV Signal Stoppage (Low Battery Voltage) (B158F)
DESCRIPTION
This DTC is stored when a video or audio signal is interrupted due to battery
voltage input to the navigation receiver assembly dropping temporarily.
DTC Code
DTC ...
Other materials:
Precaution
PRECAUTION
1. HANDLING PRECAUTIONS FOR STEERING SYSTEM
(a) Care must be taken when replacing parts. Incorrect replacement could affect
the performance of the steering system and result in driving hazards.
2. HANDLING PRECAUTIONS FOR SRS AIRBAG SYSTEM
(a) The vehicle is equipped with SRS (Suppl ...
Inverter Relay
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT INVERTER RELAY
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Condition
...
Transmission Fluid Temperature Sensor "A" Circuit Low Input (P0712,P0713)
DESCRIPTION
The No. 1 ATF temperature sensor converts the fluid temperature into a resistance
value for use by the ECM.
The ECM applies a voltage to the temperature sensor through terminal THO1 of
the ECM.
The sensor resistance changes with the ATF temperature. As the temperature becomes
hi ...
