Toyota Tacoma (2015-2018) Service Manual: Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast cannot be Added into Memory

Toyota Tacoma (2015-2018) Service Manual / Navigation / Multi Info Display / Navigation System / Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast cannot be Added into Memory

CAUTION / NOTICE / HINT

NOTICE:

Some satellite radio broadcasts require payment. A contract must be made between a satellite radio company and the user. If the contract expires, it will not be possible to listen to the broadcast.

PROCEDURE

1.	CHECK NAVIGATION RECEIVER ASSEMBLY

(a) Check radio condition.

OK:

Broadcast can be selected, but selection cannot be memorized.

REPLACE NAVIGATION RECEIVER ASSEMBLY

2.	CHECK SATELLITE RADIO

(a) Check the number of preset channels.

OK:

36 channels have already been preset.

END (ONLY 36 CHANNELS CAN BE PRESET)

3.	CHECK BATTERY

(a) Check if the battery was replaced.

OK:

Battery was not replaced.

REPLACE NAVIGATION RECEIVER ASSEMBLY

4.	ADD PRESET CHANNEL INTO MEMORY AGAIN

(a) Check if the preset channels that have been cleared can be added into memory again.

OK:

Preset channels can be added into memory.

END

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Satellite Radio Broadcast cannot be Received

CAUTION / NOTICE / HINT NOTICE: Some satellite radio broadcasts require payment. A contract must be made between a satellite radio company and the user. If the contract expires, it w ...

Traffic Information is not Displayed

CAUTION / NOTICE / HINT NOTICE: Traffic information requires payment. An "XM Nav Traffic" contract must be made between the satellite radio company and the user. If the contrac ...

Other materials:

ABS Warning Light Remains ON
DESCRIPTION The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication. If any of the following is detected, the ABS warning light remains on: The skid control ECU (brake actuator assembly) connectors are disconnected from the ...

Transfer Shift Motor Limit Switch Circuit (P17AC)
DESCRIPTION When the transfer switches modes, the TL1, TL2 and TL3 terminals of the limit switch are in one of the ON/OFF combinations listed in the table below. Terminal When 2WD Switching between 2WD and H4 When H4 Switching between H4 and ...

Open in One Side of Bus 5 Branch Line
DESCRIPTION When the CAN bus main lines are normal (no open, short to ground, short to +B or short between lines) and there is an ECU or sensor on the "Communication Bus Check" screen that is indicated as not communicating or whose connection status on the "Communication Bus Ch ...