Toyota Tacoma (2015-2018) Service Manual: Problem Symptoms Table

HINT:

• Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table.

  Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

• Inspect the fuses and relays related to this system before inspecting the suspected areas below.

Operation Check

OPERATION CHECK 1. CHECK FUNCTION (a) Check that the key reminder warning buzzer sounds. (1) With the driver side door closed, insert the key into the ignition key cylinder and then turn the key ...

Data List / Active Test

DATA LIST / ACTIVE TEST 1. READ DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing ...

Other materials:

Distance Control Switch Circuit
DESCRIPTION The distance control switch is used to set the distance for vehicle-to-vehicle distance control mode. The distance control switch is installed in the steering pad switch assembly. The vehicle-to-vehicle distance set value can be changed by operating the steering pad switch assembl ...

Air Inlet Damper Position Sensor Circuit (B1432/32)
DESCRIPTION This sensor detects the position of the air inlet damper and sends the appropriate signals to the air conditioning amplifier assembly. The position sensor is built into the No. 1 air conditioning servo assembly (fresh/recirculation damper). DTC No. DTC Detecti ...

TS and CG Terminal Circuit
DESCRIPTION In Test Mode (signal check), a malfunction in the speed sensor that cannot be detected when the vehicle is stopped can be detected while driving. Sensor check mode can be entered by connecting terminals TS and CG of the DLC3 and turning the ignition switch from off to ON. WIRING D ...