Toyota Tacoma (2015-2018) Service Manual: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
- The forward recognition camera is used by multiple systems. If any malfunctions
occur, refer to Problem Symptoms Table of each system.
- Dynamic radar cruise control system (for 2GR-FKS): Click here
.gif)
- Dynamic radar cruise control system (for 2TR-FE): Click here
- Lane departure alert system: Click here
- Pre-collision system: Click here
- Automatic high beam system: Click here @@@@
- Dynamic radar cruise control system (for 2GR-FKS): Click here
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
|
Symptom |
Suspected Area |
Link |
|---|---|---|
|
The message "Forward Camera System Unavailable Clean Windshield" is frequently displayed |
Non-Toyota genuine front wiper blades are installed |
- |
|
The front wiper rubbers are worn |
- |
|
|
A sticker, accessory or other object is obstructing the forward recognition camera |
- |
|
|
There is snow, frost, dirt, dust or oil on the windshield glass, or the windshield glass is fogged up |
- |
|
|
A glass coating has been applied to the windshield glass |
- |
|
|
The windshield glass is chipped or cracked |
- |
|
|
Non-Toyota genuine windshield glass is installed |
- |
|
|
Forward recognition camera |
|
|
|
The message "Forward Camera System Unavailable" is frequently displayed |
Immediately after the engine is started |
- |
|
The cabin temperature is extremely high |
- |
|
|
The cabin temperature is extremely low |
- |
|
|
Forward recognition camera |
|
|
|
A system that uses the forward recognition camera does not operate |
Power source circuit |
|
|
Forward recognition camera |
|
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use these procedures to troubleshoot the forward recognition camera
system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE B ...
Utility
UTILITY
NOTICE:
If the forward recognition camera has been replaced with a new one or
the windshield glass has been removed and installed, it is necessary to
perform Forward Recognit ...
Other materials:
Operation Check
OPERATION CHECK
1. CHECK REMOTE CONTROL MIRROR FUNCTION
(a) Turn the ignition switch to ON.
(b) With L on the mirror select switch selected, check that the outer rear view
mirror assembly LH surface moves up, down, left and right normally.
(c) With R on the mirror select switch selected, check ...
Automatic High Beam System does not Operate or Operation Indicator does not
Illuminate
DESCRIPTION
The main body ECU (multiplex network body ECU) controls the automatic high beam
system based on signals received from the forward recognition camera.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
When replacing the combination meter assembly, always replace it with
...
Installation
INSTALLATION
PROCEDURE
1. INSTALL BRAKE PEDAL PAD
(a) Install the brake pedal pad onto the brake pedal.
2. INSTALL BRAKE PEDAL SUPPORT ASSEMBLY
(a) Install the brake pedal support assembly with 4 nuts.
Torque:
14 N·m {145 kgf·cm, 10 ft·lbf}
(b) Connect the stop light switch connector t ...
