Toyota Tacoma (2015-2018) Service Manual: Operation Check
OPERATION CHECK
1. CHECK INTERMITTENT CONTROL FUNCTION (w/ Intermittent Time Adjustment Switch)
(a) Turn the ignition switch to ON.
(b) Turn the windshield wiper switch assembly to the INT position.
(c) Check that the intermittent operation interval can be adjusted from approximately 1.6 to 10.7 seconds by operating the intermittent timing switch.
2. CHECK WASHER-LINKED WIPER WITH DRIP-PREVENTION FUNCTION
(a) Turn the ignition switch to ON.
(b) Turn the windshield wiper switch assembly to the off position.
(c) Washer-linked Function:
(1) When the washer switch is turned on for approximately 2.2 seconds or more, washer fluid sprays and LO operation of the front wipers is performed simultaneously. After the washer switch is turned off, check that LO operation of the front wipers is performed 3 times.
(d) Drip-prevention Function:
(1) With the vehicle stopped (below approximately 4 km/h [2.5 mph]) and the front wipers not operating after washer-linked operation completes, check that the front wipers operate once and wipe off the washer fluid after approximately 3 seconds elapse.
System Diagram
SYSTEM DIAGRAM
1. FRONT WIPER AND WASHER SYSTEM
2. WASHER FLUID LEVEL WARNING SYSTEM
...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are lis ...
Other materials:
Engine does not Start
DESCRIPTION
When the key is in the vehicle and the engine switch is pressed, the certification
ECU (smart key ECU assembly) receives a signal and changes the power source mode.
In addition, when the shift lever is in P or N and the brake pedal is depressed,
the engine can be started by pressi ...
Diagnosis System
DIAGNOSIS SYSTEM
CHECK DLC3
(a) Check the DLC3.
Click here
FUNCTION OF WARNING INDICATOR AND MESSAGE
(a) If the pre-collision system is not functioning properly, the driver is warned
by the PCS warning light and a warning message displayed on the multi-information
display.
Mas ...
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT REFRIGERANT PRESSURE
(a) This method uses a refrigerant recovery unit set to locate problem areas.
Read the refrigerant pressure when the test conditions are established.
Test conditions:
Temperature at the air inlet with the air recirculation ...
