Related Tacoma materials
Noise Occurs
PROCEDURE
1.
NOISE CONDITION
(a) Check from which direction the noise comes (front left or right, or rear
left or right).
OK:
The location of the noise source can be determined.
NG
...
Slave Module Horizontal Axis Misalignment (C1AC2)
DESCRIPTION
This DTC is stored when the angle of the blind spot monitor sensor RH deviates
more than the allowable range from the horizontal axis.
HINT:
If drum tester such as a speedometer tester, brake/speedometer combination tester
or chassis dynamometer is used with the blind spot monitor ...
Removal
REMOVAL
PROCEDURE
1. REMOVE STEERING PAD
(See page )
2. REMOVE STEERING WHEEL ASSEMBLY
...