Toyota Tacoma (2015-2018) Service Manual: No Sound can be Heard from Speakers

Toyota Tacoma (2015-2018) Service Manual / Navigation / Multi Info Display / Navigation System / No Sound can be Heard from Speakers

PROCEDURE

1.	CHECK AUDIO SETTINGS

(a) Display the "Sound Settings" screen.

(b) Set volume, fader and balance to the initial values and check that sound is normal.

OK:

Audio system returns to normal.

HINT:

Sound quality adjustment measures vary according to the type of amplifier.

END

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

Noise Occurs

PROCEDURE 1. NOISE CONDITION (a) Check from which direction the noise comes (front left or right, or rear left or right). OK: The location of the noise source ca ...

Sound Quality is Bad Only when CD is Played (Volume is Too Low)

PROCEDURE 1. REPLACE CD AND RECHECK (a) Replace the CD with a known good one and recheck. (1) Check if the same malfunction occurs again. OK: Malfunction disappea ...

Other materials:

Precaution
PRECAUTION 1. PRECAUTIONS WHEN CHECKING FOR DTCS (a) When the cable is disconnected from the negative (-) battery terminal, the DTCs stored in the steering lock ECU (steering lock actuator or UPR bracket assembly) are cleared. Be sure to record any output DTCs immediately. (b) Normally, with ...

Multi-terrain Select Switch
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE MULTI-TERRAIN SELECT SWITCH (DRIVE MONITOR SWITCH) (a) Disengage the 2 claws to remove the multi-terrain select switch (drive monitor switch). Inspection ...

Components
COMPONENTS ILLUSTRATION HINT: The following specifications are for BD22AN (w/ Differential Lock). BD22AN differentials are equipped with M10 rear differential carrier to rear axel housing fasteners. ILLUSTRATION ILLUSTRATION ...