Toyota Tacoma (2015-2018) Service Manual: Invalid Data Received From Vehicle Dynamics Control Module (U0416)

Toyota Tacoma (2015-2018) Service Manual / Vf2cm Transfer / Touch Select 2-4 And High-low System / Invalid Data Received From Vehicle Dynamics Control Module (U0416)

DESCRIPTION

This DTC is detected if a wheel speed malfunction signal is sent from the skid control ECU (brake actuator assembly).

DTC No.	Detection Item	DTC Detection Condition	Trouble Area
U0416	Invalid Data Received From Vehicle Dynamics Control Module	Diagnosis Condition: Ignition switch turned to ON (3 seconds elapse after ignition switch is turned to ON) Malfunction Status: Wheel speed sensor malfunction signals from skid control ECU are received Malfunction Time: 0.06 seconds or more (malfunction signal received 1 or more times) Other: 1 trip detection logic	CAN communication system Anti-lock brake system (w/o VSC) Vehicle stability control system (w/ VSC)

PROCEDURE

1.	RECONFIRM DTC

(a) Clear the DTCs (See page (b) Check if the same DTCs are output (See page ).

(b) Check if the same DTCs are output (See page Result ).

Result

Result	Proceed to
DTC U0122 and U0416 are output	A
Only DTC U0416 is output	B
DTC is not output	C

GO TO DTC U0122

CHECK BRAKE CONTROL SYSTEM

USE SIMULATION METHOD TO CHECK

Four Wheel Drive (4WD) Low Switch Circuit Range / Performance (P2772)

DESCRIPTION This DTC is output when a malfunction in the L4 detection switch is detected. DTC No. Detection Item DTC Detection Condition Trouble Area ...

Automatic Disconnecting Differential Motor Control Circuit Open (P17A0)

DESCRIPTION This DTC is output when an open circuit in the A.D.D. shift motor drive circuit is detected. DTC No. Detection Item DTC Detection Condition ...

Other materials:

Removal
REMOVAL PROCEDURE 1. REMOVE SLIDING ROOF SIDE GARNISH LH (a) Fully open the sunshade trim sub-assembly. (b) Remove the sliding roof side garnish LH. 2. REMOVE SLIDING ROOF SIDE GARNISH RH HINT: Use the same procedure as for the LH side. 3. ...

Pressure Control Solenoid "B" Actuator Stuck Off (P07757F)
SYSTEM DESCRIPTION The ECM uses the vehicle speed signal and signals from the transmission revolution sensors (NT, SP2) to detect the actual gear (1st, 2nd, 3rd, 4th, 5th or 6th gear). The ECM compares the actual gear with the shift schedule in the ECM memory to detect mechanical problems of t ...

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: When removing the name plates or stripe tapes, heat the vehicle body or tail gate and name plates or stripe tapes using a heat light. Heating Temperature Item Temperature Vehicle Body or Tail Gate 40 to 60 ...