Toyota Tacoma (2015-2018) Service Manual: Invalid Data Received from Vehicle Dynamics Control Module (U0416)

Toyota Tacoma (2015-2018) Service Manual / Differential / Differential System(w/ Rear Differential Lock) / Invalid Data Received from Vehicle Dynamics Control Module (U0416)

DESCRIPTION

This DTC is detected if a wheel speed malfunction signal is sent from the skid control ECU (brake actuator assembly).

DTC No.	Detection Item	DTC Detection Condition	Trouble Area
U0416	Invalid Data Received From Vehicle Dynamics Control Module	Diagnosis Condition: Ignition switch turned to ON (3 seconds elapse after ignition switch is turned to ON) Malfunction Status: Wheel speed sensor malfunction signals from skid control ECU are received Malfunction Time: 0.06 seconds or more (malfunction signal received 1 or more times) Other: 1 trip detection logic	CAN communication system Anti-lock brake system (w/o VSC) Vehicle stability control system (w/ VSC)

PROCEDURE

1.	RECONFIRM DTC

(a) Clear the DTCs. (See page (b) Check if the same DTCs are output (See page )

(b) Check if the same DTCs are output (See page Result ).

Result

Result	Proceed to
DTC U0122 and U0416 are output	A
Only DTC U0416 is output	B
DTC is not output	C

GO TO DTC U0122

CHECK BRAKE CONTROL SYSTEM

USE SIMULATION METHOD TO CHECK

Diagnostic Trouble Code Chart

DIAGNOSTIC TROUBLE CODE CHART Differential System (w/ Differential Lock) DTC Code Detection Item See page P163B 4WD ECU Malfunction ...

Rear Differential Lock Solenoid Circuit Low (P17C0)

DESCRIPTION This DTC is output when a malfunction is detected due to a short to ground occurring in the differential lock coil drive circuit of the rear differential. DTC No. ...

Other materials:

USB Media Malfunction (B1585)
DESCRIPTION This DTC is stored when a malfunction occurs in a connected device. DTC No. DTC Detection Condition Trouble Area B1585 USB Device Malfunction Non mass-storage class or incompatible protocol USB device ...

Lost Communication with ECM / PCM "A" (U0100,U0129,U0142,U0151,U0163,U023A,U1104)
DESCRIPTION The combination meter communicates with the ECM, skid control ECU, power steering ECU, main body ECU (multiplex network body ECU), airbag sensor assembly, navigation receiver assembly*1, radio and display receiver assembly*2, Forward recognition camera*3 and Millimeter wave radar ...

Cruise Control Input Processor (P160700)
DESCRIPTION The ECM continuously monitors its main and sub CPUs. This self-check ensures that the ECM is functioning properly. If outputs from the CPUs are different and deviate from the standard, the ECM will illuminate the MIL and store the DTC. DTC No. Detection Item ...