Toyota Tacoma (2015-2018) Service Manual: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Differential System (w/ Differential Lock)|
DTC Code |
Detection Item |
See page |
|---|---|---|
|
P163B |
4WD ECU Malfunction |
|
|
P17BB |
Rear Differential Lock Position SW Stuck OFF |
|
|
P17BC |
Rear Differential Lock Position SW Stuck ON |
|
|
P17C0 |
Rear Differential Lock Solenoid Circuit Low |
|
|
P17C1 |
Rear Differential Lock Solenoid Circuit High |
|
|
P17CC |
Rear Differential Lock Control SW Stuck ON |
|
|
U0122 |
Lost Communication with Vehicle Dynamics Control Module |
|
|
U0416 |
Invalid Data Received from Vehicle Dynamics Control Module |
|
.gif)
Data List / Active Test
DATA LIST / ACTIVE TEST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference
values. Do not depend solely on these reference values when deciding whether ...
Invalid Data Received from Vehicle Dynamics Control Module (U0416)
DESCRIPTION
This DTC is detected if a wheel speed malfunction signal is sent from the skid
control ECU (brake actuator assembly).
DTC No.
Detection Item
DTC Detect ...
Other materials:
Initialization
INITIALIZATION
1. INITIALIZE SLIDING ROOF SYSTEM
NOTICE:
Before starting this operation, make sure that the guide rails are not
deformed and there is no foreign matter on the guide rails.
When the sliding roof glass sub-assembly or sliding roof drive cable
sub-assembly is adju ...
Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE BRAKE ACTUATOR BRACKET NO. 1
(a) Using a hexagon wrench (5 mm), remove the screw and brake actuator bracket
No. 1.
(b) Using a screwdriver, remove the fluid level warning switch connector.
2. REMOVE BRAKE M ...
Removal
REMOVAL
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting
the cable from the negative (-) battery terminal.
Therefore, make sure to read the disconnecting the cable from the negative (-)
battery terminal notices before p ...
