Toyota Tacoma (2015-2018) Service Manual: HD Radio Tuner Malfunction (B1551,B15A0,B15AD,B15B0,B15B3,B15B4,B15B7)

Toyota Tacoma (2015-2018) Service Manual / Navigation / Multi Info Display / Navigation System / HD Radio Tuner Malfunction (B1551,B15A0,B15AD,B15B0,B15B3,B15B4,B15B7)

DESCRIPTION

These DTCs are stored when a malfunction occurs in the navigation receiver assembly.

DTC No.	DTC Detection Condition	Trouble Area
B1551	When one of the conditions below is met: "HD Radio" tuner decoder malfunction "HD Radio" tuner audio output section malfunction "HD Radio" tuner decoder RF/IF malfunction	Navigation receiver assembly
B15A0	When either condition below is met: Bus malfunction EEPROM error
B15AD	When one of the conditions below is met: Short to ground or +B, or open occurs in gyro signal circuit Gyro sensor malfunction GPS receiver malfunction
B15B0	Picture circuit (TFT unit) malfunction
B15B3	When one of the conditions below is met: AM tuner PLL is unlocked FM tuner PLL is unlocked Tuner malfunction
B15B4	When one of the conditions below is met: Mechanism drive signal malfunction Load/Eject malfunction Read mechanism malfunction Mechanical malfunction
B15B7	"Bluetooth" module malfunction

PROCEDURE

CHECK DTC

(a) Clear the DTCs (See page (b) Recheck for DTCs and check if the same DTC is output again. ).

(b) Recheck for DTCs and check if the same DTC is output again.

OK:

No DTCs are output.

USE SIMULATION METHOD TO CHECK

REPLACE NAVIGATION RECEIVER ASSEMBLY

LVDS Signal Malfunction (from Extension Module) (B1532,B156C)

DESCRIPTION DTC Code DTC Detection Condition Trouble Area B1532 When one of the conditions below is met: Video signal (digit ...

Extension Module Malfunction (B1552,B158A,B15BA)

DESCRIPTION These DTCs are stored when a malfunction occurs in the extension module. DTC Code DTC Detection Condition Trouble Area B1552 ...

Other materials:

Pressure Control Solenoid "B" Electrical (Shift Solenoid Valve SL2) (P0778)
DESCRIPTION Changing from 1st to 6th is performed by the ECM turning shift solenoid valves SL1, SL2, SL3 and SL4 on and off. If an open or short circuit occurs in any of the shift solenoid valves, the ECM controls the remaining normal shift solenoid valves to allow the vehicle to be operated ...

No Sound can be Heard from Speakers
PROCEDURE 1. CHECK AUDIO SETTINGS (a) Display the "Sound Settings" screen. (b) Set volume, fader and balance to the initial values and check that sound is normal. OK: Audio system returns to normal. HINT: Sound quality adjustment measures vary acco ...

FCM Destination Information Unmatched (C1AA1)
DESCRIPTION When the forward recognition camera is replaced with a new one, the new forward recognition camera attempts to store country specification information received from the main body ECU (multiplex network body ECU) and ECM. If the country specification information stored in the forwa ...