Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Freeze Frame Data

FREEZE FRAME DATA

1. CHECK FREEZE FRAME DATA

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Navigation System / Trouble Codes.

(e) Select a PTC to display its Freeze Frame Data.

2. LIST OF FREEZE FRAME DATA

(a) Refer to "Data List / Active Test" (See page Data List / Active Test ).

Dtc Check / Clear
DTC CHECK / CLEAR 1. START DIAGNOSTIC MODE HINT: Illustrations may differ from the actual vehicle screen depending on the device settings and options. Therefore, some detailed areas may ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when dec ...

Other materials:

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows t ...

Engine Control System Malfunction (C1201)
DESCRIPTION If a malfunction in the engine control system is detected, VSC and TRAC operations are prohibited by the fail-safe function. DTC No. Detection Item DTC Detection Condition Trouble Area C1201 Engine Control System ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE NO. 1 HEATER TO REGISTER DUCT (a) Remove the 2 screws <F> and screw <D>. (b) Disengage the 2 guides to remove the No. 1 heater to register duct. 2. REMOVE NO. 3 HEATER TO REGISTER DUCT ...

В© 2011-2026 Copyright www.ttguide.net