TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Differential / Differential System(w/ Rear Differential Lock) / Invalid Data Received from Vehicle Dynamics Control Module (U0416)

Toyota Tacoma (2015-2018) Service Manual: Invalid Data Received from Vehicle Dynamics Control Module (U0416)

DESCRIPTION

This DTC is detected if a wheel speed malfunction signal is sent from the skid control ECU (brake actuator assembly).

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

U0416

Invalid Data Received From Vehicle Dynamics Control Module
  • Diagnosis Condition: Ignition switch turned to ON (3 seconds elapse after ignition switch is turned to ON)
  • Malfunction Status: Wheel speed sensor malfunction signals from skid control ECU are received
  • Malfunction Time: 0.06 seconds or more (malfunction signal received 1 or more times)
  • Other: 1 trip detection logic
  • CAN communication system
  • Anti-lock brake system (w/o VSC)
  • Vehicle stability control system (w/ VSC)

PROCEDURE

1.

RECONFIRM DTC

(a) Clear the DTCs. (See page (b) Check if the same DTCs are output (See page )

(b) Check if the same DTCs are output (See page Result ).

Result

Result

Proceed to

DTC U0122 and U0416 are output

A

Only DTC U0416 is output

B

DTC is not output

C
A

GO TO DTC U0122

B

CHECK BRAKE CONTROL SYSTEM
C

USE SIMULATION METHOD TO CHECK

    Related Tacoma materials

    Inspection
    INSPECTION PROCEDURE 1. INSPECT TIE ROD END SUB-ASSEMBLY (a) Flip the ball joint stud back and forth 5 times as shown in the illustration before installing the nut. (b) Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and check the torque reading on the ...

    Rear Center Seat Outer Belt Assembly(for Double Cab)
    Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE REAR SEATBACK HINGE COVER 2. REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY 3. REMOVE SEAT BELT ANCHOR COVER CAP 4. REMOVE REAR SEAT SHOULDER BELT COVER 5. REMOVE CENTER SEATBACK PAD (a) Remove th ...

    Check Bus 3 Line for Short to GND
    DESCRIPTION There may be a short circuit between one of the CAN bus lines and GND when there is no resistance between terminal 6 (CA3H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 21 (CA3L) of the central gateway ECU (network gateway ECU) and ...