Toyota Tacoma (2015-2018) Service Manual: Customize Parameters
CUSTOMIZE PARAMETERS
PROCEDURE
1. CUSTOMIZE SLIDING ROOF SYSTEM
HINT:
The following items can be customized.
NOTICE:
- When the customer requests a change in a function, first make sure that the function(s) can be customized.
- Be sure to make notes of the current settings before customizing.
- When troubleshooting a function, first make sure that the function is set to the default setting.
(a) Customizing with the Techstream
(1) Connect the Techstream to the DLC3.
(2) Turn the ignition switch to ON.
(3) Turn the Techstream on.
(4) Enter the following menus: Customize Setting / Slide Roof.
(5) Select the setting by referring to the table below.
|
Display |
Default |
Content |
Setting |
Relevant ECU |
|---|---|---|---|---|
|
Door Key Related Operation |
Slide |
Function to select tilt up or slide open of sliding roof key-linked function. |
Slide/Tilt |
Sliding roof ECU (Sliding roof drive gear sub-assembly) |
|
Wireless Key Related Operation |
Slide |
Function to select tilt up or slide open of sliding roof wireless transmitter-linked function. |
Slide/Tilt |
Sliding roof ECU (Sliding roof drive gear sub-assembly) |
|
Front SW Auto Operation |
ON |
This function is used to enable or disable the auto operation. |
OFF/ON |
Sliding roof ECU (Sliding roof drive gear sub-assembly) |
(6) Enter the following menus: Customize Setting / Security.
(7) Select the setting by referring to the table below.
|
Display |
Default |
Content |
Setting |
Relevant ECU |
|---|---|---|---|---|
|
Slide Roof Open Warning |
ON |
This function is used to enable or disable the sliding roof open warning. |
OFF/ON |
Main body ECU (Multiplex network body ECU) |
System Diagram
SYSTEM DIAGRAM
...
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the sliding roof system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE BROUGHT T ...
Other materials:
Brake Signal Malfunction (B2284)
DESCRIPTION
This DTC is stored when the brake signal sent via direct line and the brake signal
sent via CAN communication do not match.
HINT:
When the cable is disconnected and reconnected to the negative (-) battery terminal,
the power source mode returns to the state it was in before the ca ...
Fuel Main Valve
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
(See page )
2. REMOVE FUEL SENDER GAUGE ASSEMBLY
3. REMOVE NO. 1 FUEL SUB-TANK
4. REMOVE FUEL PUMP FILTER
5. REMOVE FUEL MAIN VALVE ASSEMBLY
(a) Remove t ...
Driver Side Power Window does not Operate with Power Window Master Switch
DESCRIPTION
When the engine is running or the ignition switch is ON, the front power window
regulator motor assembly LH is operated by the power window regulator master switch
assembly. The front power window regulator motor assembly LH has motor, regulator,
and ECU functions.
HINT:
If the ...
