General Maintenance
GENERAL MAINTENANCE
PROCEDURE
1. TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY
(a) Tighten the bolts and nuts on the chassis parts listed below, if necessary.
(b) Tighten the bolts and nuts on the body parts listed below, if necessary.
2. CLEAN OR REPLACE AIR CONDITIONING FILTER
(a) Remove the glove compartment assembly.
(b) Remove the air filter case.
(c) Remove the air conditioning filter.
(d) Visually inspect the surface of the air conditioning filter.
(e) If the air conditioning filter is contaminated with foreign matter, clean or replace it according to the maintenance schedule.
NOTICE:
Some filters are not able to be cleaned.
Maintenance
BrakeConnecting Bluetooth®
The following can be performed using Bluetooth® wireless communication: ■
A portable audio player can be operated and listened to via multimedia system
■ Hands-free phone calls can be made via a cellular phone
In order to use wireless communication, register and connect a Bluetooth ...
Input Speed Sensor Circuit No Signal (P0717,P07BF,P07C0)
DESCRIPTION
This sensor detects the rotation speed of the turbine which shows the input turbine
speed of the transmission. By comparing the input turbine speed signal (NT) with
the output shaft speed sensor signal (SP2), the ECM detects the shift timing of
the gears and appropriately controls ...
Theft Deterrent System Presence Detection (B279C,B279C95)
DESCRIPTION
If an ECM that is incompatible with the engine immobiliser system is installed,
the ECM stores this DTC.
DTC No.
DTC Detection Condition
Trouble Area
DTC Output Confirmation Operation
B279C*1
An ECM that is incom ...