Toyota Tacoma manuals

Toyota Tacoma (2005–2015) Owners Manual: Air conditioning filter

The air conditioning filter must be changed regularly to maintain air conditioning efficiency.

■ Removal method

position. Turn the engine switch to the LOCK position.

Open the glove box.

Open the glove box.

Slide off the damper.

Slide off the damper.

Push in each side of the glove box to disconnect the claws.

Push in each side of the glove box to disconnect the claws.

Open the filter door.

Open the filter door.

Remove the filter.

Remove the filter.

■ Replacement method

Remove the air conditioning filter and replace it with a new one.

Remove the air conditioning filter and replace it with a new one.

When installing the filter, follow the instructions indicated on the label.

■Checking interval

Inspect and replace the air conditioning filter according to the maintenance schedule. In dusty areas or areas with heavy traffic flow, early replacement may be required. (For scheduled maintenance information, please refer to the “Scheduled Maintenance Guide” or “Owner’s Manual Supplement”.)

■If air flow from the vents decreases dramatically

The filter may be clogged. Check the filter and replace if necessary.

NOTICE

■When using the air conditioning system

Make sure that a filter is always installed.

Using the air conditioning system without a filter may cause damage to the system.

Wheels
If a wheel is bent, cracked or heavily corroded, it should be replaced. Otherwise, the tire may separate from the wheel or cause loss of handling control. ■ Wheel selection When replacing whe ...

Wireless remote control battery
Replace the battery with a new one if it is discharged. ■ You will need the following items: Lithium battery CR2032 ■ Replacing the battery Remove the cover using a coin protected wi ...

Other materials:

Components
COMPONENTS ILLUSTRATION *1 INSTRUMENT LOWER PANEL ASSEMBLY *2 INSTRUMENT PANEL LOWER CENTER FINISH PANEL *3 NO. 2 INSTRUMENT PANEL GARNISH SUB-ASSEMBLY *4 REAR NO. 2 POWER WINDOW REGULATOR SWITCH ASSEMB ...

Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)
DESCRIPTION This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH. HINT: This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the be ...

Rear Airbag Sensor RH Circuit Malfunction (B1630/23)
DESCRIPTION The airbag sensor RH consists of parts such as the safing sensor, the diagnostic circuit and the lateral deceleration sensor. When the airbag sensor assembly receives signals from the lateral deceleration sensor, it determines whether or not the SRS should be activated. DTC B1630/ ...

© 2011-2026 Copyright www.ttguide.net