Toyota Tacoma manuals

Toyota Tacoma 2015-2018 Service Manual: Sound of Portable Player cannot be Heard from Speakers or Sound is Low

Toyota Tacoma 2015-2018 Service Manual / Audio / Video / Audio And Visual System / Sound of Portable Player cannot be Heard from Speakers or Sound is Low

PROCEDURE

1.

CHECK PORTABLE PLAYER SETTINGS

(a) Check the portable player settings.

(1) Check that the volume is not set to "0".

(2) Check that the mute is off.

(b) Check that the sound of the portable player can be heard from the speakers.

OK:

Sound of the portable player can be heard from the speakers.

OK

END

NG

2.

CHECK AUDIO SETTINGS

(a) Check the audio settings.

(1) Check that the volume is not set to "0".

(b) Check that the sound of the portable player can be heard from the speakers.

OK:

Sound of the portable player can be heard from the speakers.

OK

END

NG

3.

CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL

(a) Check that the sound of the portable player can be heard from the speakers on another "Bluetooth" audio compatible vehicle of the same model.

OK:

Sound of the portable player can be heard from the speakers.

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

MALFUNCTION IN PORTABLE PLAYER

Confirm Cellular Phone Functionality
PROCEDURE 1. CHECK CUSTOMER'S CELLULAR PHONE COMPATIBILITY (a) Check if the cellular phone is compatible (Refer to http://www.toyota.com/entune/). Result ...

Does not Play even after Bluetooth Audio Mode is Selected
CAUTION / NOTICE / HINT HINT: Even if the portable player can play audio content, it may not be able to play via the in-vehicle device. This does not necessarily indicate a malfunction of the in ...

Other materials:

Dtc Check / Clear
DTC CHECK / CLEAR 1. CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the back sonar or clearance sonar switch assembly on. (d) Turn the Techstream on. (e) Enter the following menus: Body Electrical / Intuitive P/A / Trouble Codes. (f) Check for D ...

Inspection
INSPECTION PROCEDURE 1. INSPECT REAR AXLE SHAFT (a) Using a dial indicator, measure the runout of the shaft and flange. Maximum runout: Shaft runout: 1.5 mm (0.0591 in.) Flange runout: 0.05 mm (0.0020 in.) If the rear axle shaft or flange is damaged or worn, or the runout is greater than ...

Crankshaft Position Sensor "A" Signal Stuck in Range (P03352A,P033531)
DESCRIPTION The crankshaft position sensor system consists of a crankshaft position sensor plate and a pickup coil. The crankshaft position sensor plate has 34 teeth and is installed to the crankshaft. The pickup coil is made of wound copper wire, an iron core and a magnet. The crankshaft pos ...

В© 2011-2021 Copyright www.ttguide.net