Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Magnetic Clutch Relay

Inspection

INSPECTION

PROCEDURE

1. INSPECT MAGNET-CLUTCH RELAY

(a) Check the resistance.

(1) Using an ohmmeter, measure the resistance between the terminals.

Standard:

Tester Connection

Specified Condition

3 - 5

10 kΩ or higher

3 - 5

Below 1 Ω

(Apply battery voltage to terminals 1 and 2)

If the result is not as specified, replace the relay.

Heater Relay
Inspection INSPECTION PROCEDURE 1. INSPECT HEATER RELAY (a) Check the resistance. (1) Using an ohmmeter, measure the resistance between each terminal. Standard: ...

Ptc Heater Assembly
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (See page ) 2. REMOVE INSTRUMENT LOWER PANEL ASSEMBLY 3. REMOVE ...

Other materials:

Installation
INSTALLATION CAUTION / NOTICE / HINT CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page ). If the side airbag was deployed, replace the front seat assembly with ...

Removal
REMOVAL PROCEDURE 1. REMOVE ROOF HEADLINING ASSEMBLY (for LED Type Stop Light) for Double Cab: (See page ) for Access Cab: (See page ) 2. REMOVE CENTER STOP LIGHT ASSEMBLY (for Bulb Type Stop Light) (a) Apply protective tape around the center stop light as ...

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK DRIVER SIDE JUNCTION BLOCK AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (a) Disconnect the MB main body ECU (multiplex network body ECU) connectors. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on ...

© 2011-2026 Copyright www.ttguide.net