Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT MAIN SWITCH ASSEMBLY
(a) Check the main switch assembly.
(1) Measure the resistance according to the value(s) in the table below. Text in Illustration
Standard Resistance:
|
|
(b) Check the switch indicator.
(1) Apply battery voltage to the main switch assembly and check that the switch indicator illuminates.
OK:
Measurement Condition |
Switch Condition |
Specified Condition |
---|---|---|
Battery positive (+) → 5 (IND+) Battery positive (-) → 2 (IND-) |
Always |
Illuminates |
OK:
Measurement Condition |
Switch Condition |
Specified Condition |
---|---|---|
Battery positive (+) → 6 (IG) Battery positive (-) → 4 (IND) |
Always |
Illuminates |
Removal
REMOVAL
PROCEDURE
1. REMOVE INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY RH
(See page )
2. REMOVE MAIN SWITCH ASSEMBLY
(a) Disengage the 2 claws to remove the main switch assembly. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL MAIN SWITCH ASSEMBLY
(a) Engage the 2 claws to install the main switch assembly.
2. INSTALL INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY RH
(See page )
Check Bus 3 Line for Short to +B
DESCRIPTION
There may be a short circuit between one of the CAN bus lines and +B when no
resistance exists between terminal 6 (CA3H) of the central gateway ECU (network
gateway ECU) and terminal 16 (BAT) of the DLC3, or terminal 21 (CA3L) of the central
gateway ECU (network gateway ECU) and t ...
Rear Cross Traffic Alert Buzzer
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR CROSS TRAFFIC ALERT BUZZER
(a) Engage the clamp to install the rear cross traffic alert buzzer.
(b) Connect the connector.
2. INSTALL QUARTER INSIDE TRIM BOARD LH (for Double Cab)
(See page )
3. ...
Radio Receiver
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY
(See page )
2. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET
(a) Remove the 4 bolts.
...