Toyota Tacoma (2015-2018) Service Manual: Wireless Charger Assembly
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT CONSOLE BOX
(See page .gif)
)
2. REMOVE MOBILE WIRELESS CHARGER CRADLE ASSEMBLY
|
(a) Remove the 5 screws and mobile wireless charger cradle assembly. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL MOBILE WIRELESS CHARGER CRADLE ASSEMBLY
(a) Install the mobile wireless charger cradle assembly with the 5 screws.
2. INSTALL FRONT CONSOLE BOX
(See page .gif)
)
Voltage Inverter
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT VOLTAGE INVERTER ASSEMBLY
(a) Check the voltage inverter assembly.
(1) Measure the voltage according to the ...
Wireless Charger Main Switch
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE INSTRUMENT PANEL LOWER CENTER FINISH PANEL
(See page )
2. REMOVE MOBILE WIRELESS CHARGER SWITCH
(a) Di ...
Other materials:
Steering Angle Sensor (C1A47)
DESCRIPTION
The millimeter wave radar sensor assembly receives steering angle information
from the steering angle sensor (spiral cable with sensor sub-assembly). If the millimeter
wave radar sensor assembly detects a steering angle sensor (spiral cable with sensor
sub-assembly) malfunction, D ...
Yaw Rate Sensor Circuit (C1AA4,C1AA5)
DESCRIPTION
The forward recognition camera receives vehicle stability signals from the yaw
rate and acceleration sensor (airbag sensor assembly). If the yaw rate and acceleration
sensor (airbag sensor assembly) detects an abnormal yaw rate sensor signal or yaw
rate sensor assembly power suppl ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY
(a) Using a dial indicator, check the propeller shaft runout.
Maximum runout:
0.6 mm (0.0236 in.)
If the shaft runout is greater than the maximum, replace the shaft.
2. INSPECT PROPELLER SHAFT
(a) Using a dial ...
