Toyota Tacoma manuals

Toyota Tacoma (2005–2015) Owners Manual: Vehicle load limits

Vehicle load limits include total load capacity, seating capacity, TWR (Trailer Weight Rating) and cargo capacity.

■ Total load capacity (vehicle capacity weight):

Total load capacity means the combined weight of occupants, cargo and luggage.

■ Seating capacity:

With separated type seats— 2 occupants Regular Cab models

With separated type seats— 2 occupants

With bench type seat— 3 occupants

4 occupants (Front 2, Rear 2) Access Cab models

4 occupants (Front 2, Rear 2)

5 occupants (Front 2, Rear 3) Double Cab models

5 occupants (Front 2, Rear 3)

Seating capacity means the maximum number of occupants whose estimated average weight is 150 lb. (68 kg) per person.

Even if the number of occupants are within the seating capacity, do not exceed the total load capacity.

■ TWR (Trailer Weight Rating):

TWR means the maximum gross trailer weight (trailer weight plus its cargo weight) that your vehicle is able to tow.

■ Cargo capacity

Cargo capacity may increase or decrease depending on the weight and the number of occupants.

■Total load capacity and seating capacity

These details are also described on the tire and loading information label.

CAUTION

■Overloading the vehicle

Do not overload the vehicle.

It may not only cause damage to the tires, but also degrade steering and braking ability, resulting in an accident.

Cargo and luggage
Take notice of the following information about storage precautions, cargo capacity and load. ● Stow cargo and luggage in the rear deck whenever possible. ● Be sure all items are secure ...

Winter driving tips
Carry out the necessary preparations and inspections before driving the vehicle in winter. Always drive the vehicle in a manner appropriate to the prevailing weather conditions. ■ Pre-winte ...

Other materials:

Disassembly
DISASSEMBLY PROCEDURE 1. INSPECT 3RD GEAR THRUST CLEARANCE (a) Using a dial indicator, measure the 3rd gear thrust clearance. Standard clearance: 0.200 to 0.490 mm (0.0079 to 0.0192 in.) If the clearance is outside the specification, replace the 3rd gear, thrust washer, c ...

Inspection
INSPECTION PROCEDURE 1. INSPECT FUEL PUMP (a) Inspect the resistance of the fuel pump. (1) Measure the resistance according to the value(s) in the table below. Text in Illustration *a Component without harness connected (Fuel Pump) ...

Immobiliser System does not Operate Properly
DESCRIPTION The engine immobiliser system compares the ID code that is registered in the certification ECU (smart key ECU assembly) with the ID code of the transponder chip that is embedded in the electrical key transmitter sub-assembly. WIRING DIAGRAM (See page ). CAUTION / NOTICE / HINT ...

© 2011-2026 Copyright www.ttguide.net