Glare from the headlights of vehicles behind can be reduced by using the following functions.
Manual anti-glare inside rear view mirror
Normal position
Anti-glare position
Auto anti-glare inside rear view mirror (type A)
In automatic mode, sensors are used to detect the headlights of vehicles behind and automatically reduces the reflected light.
Turns automatic mode on/off
The indicator comes on when automatic mode is turned on.
The mirror will revert to the automatic mode each time the engine switch is turned on.
Auto anti-glare inside rear view mirror (type B)
In automatic mode, sensors are used to detect the headlights of vehicles behind and automatically reduces the reflected light.
Turns automatic mode on/off
The indicator comes on when automatic mode is turned on.
The mirror will revert to the automatic mode each time the engine switch is turned on.
Adjusting the height of rear view mirror
Adjust the height of the rear view mirror by moving it up and down.
Inside rear view mirror display (vehicles with auto anti-glare inside rear view mirror)
The inside rear view mirror displays the following information.
■ Compass
■ Garage door opener
■To prevent sensor error (vehicles with auto anti-glare inside rear view mirror)
To ensure that the sensors operate properly, do not touch or cover them.
CAUTION
■Caution while driving
Do not adjust the position of the mirror while driving.
Doing so may lead to mishandling of the vehicle and cause an accident, resulting in death or serious injury.
Inspection
INSPECTION
PROCEDURE
1. INSPECT MAGNET STARTER SWITCH ASSEMBLY
(a) Inspect the pull-in coil.
(1) Measure the resistance according to the value(s) in the table below.
Text in Illustration
*a
Terminal 50
*b
...
Installation
INSTALLATION
PROCEDURE
1. INSTALL CLUTCH DISC ASSEMBLY
(a) Insert SST into the clutch disc assembly, and then install SST and the clutch
disc assembly together to the flywheel sub-assembly.
Text in Illustration
Flywheel Sub-assembly Side
SST: 09301-00220
NOTICE ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL COOLER (ROOM TEMPERATURE SENSOR) THERMISTOR
(a) Connect the cooler air hose.
(b) Connect the connector.
(c) Engage the 2 claws to connect the cooler (room temperature sensor ) thermistor.
2. INSTALL INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY RH
3. I ...