DESCRIPTION
DTC Code |
DTC Detection Condition |
Trouble Area |
DTC Output Confirmation Operation |
---|---|---|---|
B2793 |
A transponder chip malfunction (1 trip detection logic*). |
|
Insert the key into the ignition key cylinder, turn the ignition switch from off to ON and wait at least 20 seconds. |
B2794 |
A key with an incomplete key ID code is used to turn the ignition switch to ON (1 trip detection logic*). |
||
B2797 |
A key with a BCC malfunction is used to turn the ignition switch to ON (1 trip detection logic*). |
||
B2798 |
Key ID code identification cannot be completed within the specified time (1 trip detection logic*). |
Vehicle Condition when Malfunction Detected |
Fail-safe Operation when Malfunction Detected |
---|---|
Engine cannot be started |
- |
DTC No. |
Data List and Active Test |
---|---|
B2793 |
- |
B2794 |
- |
B2797 |
- |
B2798 |
- |
CAUTION / NOTICE / HINT
NOTICE:
PROCEDURE
1. |
CLEAR DTC |
(a) Clear the DTCs (See page ).
|
2. |
CHECK DTC OUTPUT |
(a) Perform "DTC Output Confirmation Operation" procedure.
(b) Check for DTCs (See page ).
HINT:
If DTC B2793, B2794, B2797, or B2798 is stored, clear the DTCs before checking the next key.
OK:
DTC B2793, B2974, B2797 and B2798 are not output.
Result
Result |
Proceed to |
---|---|
DTCs are output for all of the keys |
A |
DTCs are output for any of the keys |
B |
DTCs are not output |
C |
B |
REPLACE KEY THAT DTC IS OUTPUT |
C |
USE SIMULATION METHOD TO CHECK |
|
3. |
CHECK CONNECTION OF CONNECTOR |
(a) Check that the connector is properly connected to the transponder key coil.
(b) Check that the engine starts with the key.
OK:
Engine starts normally.
OK |
END (CONNECTOR WAS NOT CONNECTED PROPERLY) |
|
4. |
REPLACE TRANSPONDER KEY COIL |
(a) Clear the DTCs (See page ).
(b) Replace the transponder key coil (See page ).
(c) Check that the engine starts with the key (See page ).
OK:
Engine starts normally.
OK |
END (TRANSPONDER KEY COIL WAS DEFECTIVE) |
NG |
REPLACE TRANSPONDER KEY ECU ASSEMBLY |
Back window (vehicles with sliding type)
The back window can be opened and closed using the lock release lever.
Open/close
Push the lock release lever and slide the back window.
■Closing the back window
Make sure that the back window is securely closed after closing it.
CAUTION
■While driving
Keep the back window close ...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. INSTALL FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY
(a) Engage the 5 claws to install the front door glass outer ...
Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Chassis / LKA/LDA / Trouble Codes.
(e) Check for DTCs.
Click here
CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn ...