PROCEDURE
1. |
CHECK MULTI-DISPLAY |
(a) Check if there is any foreign matter caught between the display and exterior frame of the multi-display.
OK:
No foreign matter is caught between the display and exterior frame of the multi-display.
HINT:
If there is foreign matter between the display and exterior frame of the multi-display, the touch panel will remain pressed, preventing touch switch operation.
NG |
REMOVE FOREIGN MATTER |
|
2. |
CHECK TOUCH PANEL |
(a) Check for foreign matter on the display.
OK:
The display is clean.
NG |
CLEAN DISPLAY AND RECHECK TOUCH PANEL |
|
3. |
CHECK TOUCH SWITCH (OPERATION CHECK) |
(a) Enter the "Touch Switch Check" screen. Refer to Check Touch Switch in Operation Check (See page ).
(b) Touch the display in the area where the switch malfunction occurs.
OK:
A "+" mark appears at the touched position.
OK |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
NG |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
Lost Communication With ECM/PCM "A" Missing Message (U010087,U010487,U012287)
DESCRIPTION
The ECM communicates with each sensor and ECU via CAN communication.
If any malfunction is detected in a CAN communication circuit, one or more CAN
communication system DTCs are stored.
DTC No.
Detection Item
DTC Detection Condition
Troubl ...
Removal
REMOVAL
PROCEDURE
1. REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System)
(See page )
2. REMOVE INTEGRATION PANEL SUB-ASSEMBLY (for Manual Cooler System)
(See page )
3. REMOVE TRANSFER POSITION SWITCH
(a) Detach the 2 claws to remove the transfer pos ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL WINDSHIELD WIPER MOTOR ASSEMBLY
(a) Apply MP grease to the crank arm pivot of the windshield wiper motor
assembly.
Text in Illustration
*1
Crank Arm Pivot
...