DESCRIPTION
See page .
WIRING DIAGRAM
See page .
CAUTION / NOTICE / HINT
NOTICE:
PROCEDURE
1. |
INSPECT BATTERY |
(a) Measure the voltage of the battery.
Standard Voltage:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
Battery |
Always |
11 to 14 V |
NG |
CHECK AND REPLACE BATTERY OR CHARGING SYSTEM |
|
2. |
CHECK CONNECTION OF CONNECTORS |
(a) Turn the ignition switch off.
(b) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
(c) Check that the connectors are properly connected to the airbag sensor assembly and the combination meter assembly.
OK:
The connectors are properly connected.
NG |
CONNECT CONNECTORS PROPERLY |
|
3. |
CHECK HARNESS AND CONNECTOR (SOURCE VOLTAGE OF COMBINATION METER ASSEMBLY) |
(a) Turn the ignition switch off. |
|
(b) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
(c) Disconnect the connectors from the combination meter assembly.
(d) Connect the cable to the negative battery terminal, and wait for at least 2 seconds.
(e) Turn the ignition switch to ON.
(f) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
C9-20 (IG+) - C9-18 (ES) |
Ignition switch ON |
11 to 14 V |
*a |
Front view of wire harness connector (to Combination Meter Assembly) |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
4. |
CHECK SRS WARNING LIGHT |
(a) Turn the ignition switch off.
(b) Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
(c) Connect the connector to the combination meter assembly.
(d) Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
(e) Turn the ignition switch to ON.
(f) Check the SRS warning light condition.
OK:
The SRS warning light turns off after the primary check period and comes on again after approximately 10 seconds.
HINT:
The primary check period lasts for approximately 6 seconds after the ignition switch is turned to ON.
OK |
REPLACE AIRBAG SENSOR ASSEMBLY |
NG |
REPLACE COMBINATION METER ASSEMBLY |
Replacement
REPLACEMENT
CAUTION / NOTICE / HINT
CAUTION:
Prolonged and repeated contact with engine oil will result in the removal
of natural oils from the skin, leading to dryness, irritation and dermatitis.
In addition, used engine oil contains potentially harmful contaminants which
may ...
Engine does not Start because No Initial Combustion
DESCRIPTION
When a key is inserted into the ignition key cylinder, the transponder
key coil receives the key ID code and sends it to the transponder key ECU
assembly.
If an error in communication between the transponder key coil and transponder
key ECU assembly occurs, this s ...
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL FRONT LOWER ARM BUSH NO. 1
(a) Install a new lower arm bush using SST, a press and steel plate.
SST: 09631-12090
SST: 09631-32020
NOTICE:
Push the lower arm bush in until the bush positioning protrusions come to the
positions shown in the illustration.
2. ...