Toyota Tacoma (2015-2018) Service Manual: Airbag System
- Parts Location
- Precaution
- System Diagram
- How To Proceed With Troubleshooting
- Problem Symptoms Table
- System Description
- Check Mode Procedure
- Diagnosis System
- Dtc Check / Clear
- Terminals Of Ecu
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Vehicle Control History
- Short in Front Passenger Side Squib 2nd Step Circuit (B1815/54-B1818/54)
- Short in Side Squib RH Circuit (B1820/55-B1823/55)
- Short in Side Squib LH Circuit (B1825/56-B1828/56)
- Short in Curtain Shield Squib RH Circuit (B1830/57-B1833/57)
- Short in Curtain Shield Squib LH Circuit (B1835/58-B1838/58)
- Short in Driver Side Knee Airbag Squib Circuit (B1860/64-B1863/64)
- Short in Front Passenger Side Knee Airbag Squib Circuit (B1865/65-B1868/65)
- Short in Front Passenger Side Squib Circuit (B1805/52-B1808/52)
- Short in Driver Side Squib 2nd Step Circuit (B1810/53-B1813/53)
- Seat Belt Buckle Switch LH Circuit Malfunction (B1656/38)
- Occupant Classification System Malfunction (B1650/32)
- Seat Position Airbag Sensor Circuit Malfunction (B1653/35)
- Side Airbag Sensor LH Circuit Malfunction (B1625/22)
- Rear Airbag Sensor RH Circuit Malfunction (B1630/23)
- Rear Airbag Sensor LH Circuit Malfunction (B1635/24)
- Center Airbag Sensor Assembly Malfunction (B1000/31)
- Front Airbag Sensor LH Circuit Malfunction (B1615/14)
- Side Airbag Sensor RH Circuit Malfunction (B1620/21)
- Front Airbag Sensor RH Circuit Malfunction (B1610/13)
- SRS Warning Light does not Come ON
- SRS Warning Light Remains ON
- TC and CG Terminal Circuit
Parts Location
PARTS LOCATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
...
Other materials:
Installation
INSTALLATION
PROCEDURE
1. INSTALL STEERING COLUMN ASSEMBLY
(a) Install the steering column assembly with the 2 nuts and bolt.
Torque:
21 N·m {214 kgf·cm, 15 ft·lbf}
(b) Connect each of the connectors to the steering column assembly.
(c) Connect the wire harness clamps to the steering colu ...
Front Stabilizer Bar
Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT STABILIZER LINK ASSEMBLY
(a) Flip the ball joint stud back and forth 5 times, as shown in the illustration,
before installing the nut.
(b) Using a torque wrench, turn the nut continuously at a rate ...
Vehicle Speed Sensor "A" No Signal (P050031)
DESCRIPTION
The speed sensor detects the wheel speed and sends the appropriate signals to
the skid control ECU. The skid control ECU converts these wheel speed signals into
a pulse signal and outputs it to the ECM via the combination meter. The ECM determines
the vehicle speed based on the fr ...
