Toyota Tacoma (2015-2018) Service Manual: Reassembly
REASSEMBLY
CAUTION / NOTICE / HINT
NOTICE:
Do not try to remove the black nylon tube as it is welded to the fuel suction
tube assembly (See page .gif)
).
HINT:
Perform "Inspection After Repairs" after replacing the fuel pump (See page
).
PROCEDURE
1. INSTALL FUEL PUMP
HINT:
Perform "Inspection After Repairs" after replacing the fuel pump (See page
).
|
(a) Apply a light coat of gasoline to a new O-ring. Then install the fuel pump spacer and O-ring to the fuel pump. Text in Illustration
|
|
|
(b) Connect the fuel pump harness connector and install the fuel pump harness to the fuel pump. |
|
.png)
|
(c) Install the fuel pump to the fuel filter case. NOTICE: Make sure that the O-ring is not cut or pinched during the installation. |
|
|
(d) Engage the 2 claws and install the No. 1 fuel suction support to the fuel filter case. |
|
.png)
|
(e) Engage the clamp and connect the wire harness. |
|
.png)
2. INSTALL FUEL PUMP FILTER
|
(a) Engage the claw and connect the fuel pump harness to the fuel pump filter. |
|
.png)
|
(b) Engage the 3 claws and install the fuel pump filter to the fuel filter case. |
|
.png)
3. INSTALL NO. 1 FUEL SUB-TANK
|
(a) Engage the 5 claws and install the No. 1 fuel sub-tank. |
|
.png)
|
(b) While aligning with the installation position of the No. 1 fuel sub-tank, install the jet pump. |
|
(c) Engage the 2 clamps and claw and connect the jet pump nozzle to the No. 1 fuel sub-tank.
|
(d) Engage the clamp and connect the wire harness. |
|
.png)
(e) Connect the 2 fuel pump connectors.
4. INSTALL FUEL SENDER GAUGE ASSEMBLY
Installation
INSTALLATION
PROCEDURE
1. INSTALL FUEL SUCTION TUBE SET GASKET
(a) Ensure gasket groove is clean and free of foreign particles.
(b) Install a new gasket onto the fuel tank.
...
Fuel Pump Ecu
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting
the cable fr ...
Other materials:
Freeze Frame Data
FREEZE FRAME DATA
CHECK FREEZE FRAME DATA
HINT:
The ECU records vehicle and driving condition information as freeze frame data
the moment a DTC is stored.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: P ...
Precaution
PRECAUTION
PRECAUTION WHEN REPLACING COMBINATION METER ASSEMBLY
(a) When replacing the combination meter assembly, always replace it with a new
one. If a combination meter assembly which was installed to another vehicle is used,
the information stored in it will not match the information from ...
Fail-safe Chart
FAIL-SAFE CHART
If any of the following DTCs are stored, the ECM enters fail-safe mode to allow
the vehicle to be driven temporarily.
DTC
Fail-safe Operation
Fail-safe Deactivation Condition
P161A87
Generator command is maintained
...
