Toyota Tacoma (2015-2018) Service Manual: Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY
(a) Using hot-melt glue, install the No. 2 antenna cord sub-assembly as shown in the illustration.
.png)
2. INSTALL NO. 1 ROOF WIRE (w/ Vanity Light)
(a) w/ EC Mirror:
(1) Align the aiming tape as shown in the illustration.
|
*a |
Aiming Tape |
*b |
Adjustment Are |
(2) Using hot-melt glue, install the No. 1 roof wire.
NOTICE:
Do not apply hot-melt glue to the position A shown in the illustration.
HINT:
Use the adjustment area to accommodate any excess length of the No. 1 roof wire.
(b) w/o EC Mirror:
(1) Align the aiming tape as shown in the illustration.
|
*a |
Aiming Tape |
*b |
Adjustment Are |
(2) Using hot-melt glue, install the No. 1 roof wire.
NOTICE:
Do not apply hot-melt glue to the position A shown in the illustration.
HINT:
Use the adjustment area to accommodate any excess length of the No. 1 roof wire.
3. INSTALL NO. 1 ROOF WIRE (w/o Vanity Light)
(a) w/ EC Mirror:
(1) Align the aiming tape as shown in the illustration.
|
*a |
Aiming Tape |
- |
- |
(2) Using hot-melt glue, install the No. 1 roof wire.
NOTICE:
Do not apply hot-melt glue to the position A shown in the illustration.
(b) w/o EC Mirror:
(1) Align the aiming tape as shown in the illustration.
|
*a |
Aiming Tape |
- |
- |
(2) Using hot-melt glue, install the No. 1 roof wire.
NOTICE:
Do not apply hot-melt glue to the position A shown in the illustration.
4. INSTALL MICROPHONE CASE
HINT:
Use the same procedure for Double Cab.
Click here .gif)
5. INSTALL TELEPHONE MICROPHONE ASSEMBLY
Click here
Installation
INSTALLATION
PROCEDURE
1. INSTALL ROOF HEADLINING ASSEMBLY
(a) Insert the roof headlining assembly into the vehicle from the door.
NOTICE:
Check that the corners of th ...
Other materials:
Lost Communication with Vehicle Dynamics Control Module Missing Message (U012287)
DESCRIPTION
The ECM receives signals from the skid control ECU (brake actuator assembly)
via CAN communication.
DTC No.
DTC Detection Condition
Trouble Area
MIL
Note
U012287
While cruise control main switch ON, co ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT OUTER MIRROR LH
(a) Check the outer mirror heater operation.
Text in Illustration
*a
Component without harness connected
(Outer Mirror LH)
(1) Measure the resistance according to the value(s) ...
Data List / Active Test
DATA LIST / ACTIVE TEST
1. DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches,
sensors, actuators and other items to be read without removing any parts. This non-intrusive
inspection can be very useful because intermittent conditions or signals ...
