PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Clutch System
Symptom |
Suspected Area |
See page |
---|---|---|
Clutch grabs/chatters |
Engine mounting (Loose) |
- |
Clutch disc (excessive runout) (for RC62F) |
|
|
Clutch disc (oily) (for RC62F) |
|
|
Clutch disc (worn out) (for RC62F) |
|
|
Clutch disc torsion spring (damage) (for RC62F) |
|
|
Clutch disc (glazed) (for RC62F) |
|
|
Diaphragm spring (tip out of alignment) (for RC62F) |
|
|
Clutch pedal spongy |
Clutch line (air in line) |
- |
Clutch master cylinder (damaged) |
|
|
Clutch release cylinder cup (damaged) (for RC62F) |
|
|
Clutch noisy |
Clutch release bearing (worn, dirty, or damaged) (for RC62F) |
|
Clutch disc torsion spring (damaged) (for RC62F) |
|
|
Clutch slips |
Clutch pedal (free play out of adjustment) |
|
Clutch disc (oily) (for RC62F) |
|
|
Clutch disc (worn out) (for RC62F) |
|
|
Diaphragm spring (damaged) (for RC62F) |
|
|
Pressure plate (distortion) (for RC62F) |
|
|
Flywheel (distortion) (for RC62F) |
|
|
Clutch does not disengage |
Clutch pedal (free play out of adjustment) |
|
Clutch line (air in line) |
- |
|
Clutch master cylinder (damaged) |
|
|
Clutch release cylinder cup (damaged) (for RC62F) |
|
|
Clutch disc (out of line) (for RC62F) |
|
|
Clutch disc (excessive runout) (for RC62F) |
|
|
Clutch disc (lining broken) (for RC62F) |
|
|
Clutch disc (dirty or burned) (for RC62F) |
|
|
Clutch disc (oily) (for RC62F) |
|
|
Clutch disc (lack of spline grease) (for RC62F) |
|
Radio Broadcast cannot be Received or Poor Reception
PROCEDURE
1.
CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY
(a) Check the radio automatic station search function.
(1) Check the radio automatic station search function by activating it.
Result
Result
Proceed to
Automatic station ...
Reassembly
REASSEMBLY
CAUTION / NOTICE / HINT
NOTICE:
When installing the hood bulge protector, heat the hood bulge surface
using the infrared light.
Do not heat the hood bulge excessively.
Item
Temperature
Hood Bulge
...
Stop Light Relay Circuit (C1A4B)
DESCRIPTION
The skid control ECU (master cylinder solenoid)*1 or skid control ECU (brake
actuator assembly)*2 sends a stop light operation request signal to the stop light
relay (stop light switch assembly). If the skid control ECU (master cylinder solenoid)*1
or skid control ECU (brake actua ...