PROCEDURE
1. |
CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY |
(a) Check the radio automatic station search function.
(1) Check the radio automatic station search function by activating it.
Result
Result |
Proceed to |
---|---|
Automatic station search function does not stop |
A |
Automatic station search function stops on a station |
B |
B |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
|
2. |
CHECK OPTIONAL COMPONENTS |
(a) Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna, are installed.
Result
Result |
Proceed to |
---|---|
Optional components are not installed |
A |
Optional components are installed |
B |
NOTICE:
Do not remove optional components without the permission of the customer.
B |
REMOVE OPTIONAL COMPONENTS AND CHECK AGAIN (SEE NOTICE ABOVE) |
|
3. |
CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY |
(a) Preparation for check (1) Remove the antenna connector from the radio and display receiver assembly. |
|
(b) Check for noise
(1) Turn the ignition switch to ACC with the radio and display receiver assembly connector connected.
(2) Turn the radio on and tune into AM mode.
(3) Place a screwdriver, thin wire or other metal object on the radio and display receiver assembly antenna jack and check that noise can be heard from the speakers.
OK:
Noise can be heard from the speakers.
NG |
REPAIR RADIO AND DISPLAY RECEIVER ASSEMBLY |
|
4. |
INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY |
(a) Disconnect the radio and display receiver assembly connector. |
|
(b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection |
Switch Condition |
Specified Condition |
---|---|---|
RA-5 (ANT+) - Body ground |
Ignition switch ACC Radio switch on and FM or AM selected |
11 to 14 V |
*a |
Component without harness connected (Radio and Display Receiver Assembly) |
NG |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
|
5. |
REPLACE ANTENNA CORD SUB-ASSEMBLY |
(a) Replace the antenna cord sub-assembly and check if radio broadcasts can be received normally (See page ).
OK:
Radio broadcasts can be received normally.
OK |
END |
|
6. |
REPLACE NO. 2 ANTENNA CORD SUB-ASSEMBLY |
(a) Replace the No. 2 antenna cord sub-assembly with a new or known good one and check if radio broadcasts can be received normally (See page ).
OK:
Radio broadcasts can be received normally.
OK |
END |
|
7. |
REPLACE ANTENNA ASSEMBLY WITH HOLDER |
(a) Replace the antenna assembly with holder and check if radio broadcasts can be received normally (See page ).
OK:
Radio broadcasts can be received normally.
OK |
END |
NG |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
Dtc Check / Clear
DTC CHECK / CLEAR
1. DTC CHECK
HINT:
When DTC B1650/23 is detected as a result of troubleshooting for the
airbag system, troubleshoot the occupant classification system.
Use the Techstream to read and clear DTCs, otherwise the DTCs cannot
be read and cleared.
(a) Check ...
Terminals Of Ecu
TERMINALS OF ECU
1. COMBINATION METER ASSEMBLY
(a) Measure the voltage, resistance and check for pulses according to the value(s)
in the table below.
Terminal No. (Symbol)
Wiring Color
Terminal Description
Condition
Specified Condition
...
Removal
REMOVAL
CAUTION / NOTICE / HINT
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary
notices concerning the SRS airbag system before servicing (See page
).
HINT:
Use the same procedure for both the RH and LH sides.
The procedure describe ...