PRECAUTION
1. REMOVAL AND INSTALLATION OF TIRE PRESSURE WARNING VALVE AND TRANSMITTER
(a) When installing a tire, make sure that the tire pressure warning valve and transmitter does not interfere with the tire bead in order to prevent damage to the sensor.
(b) After completing the operation, remove the valve core to rapidly release air and check that the warning light comes on. If not, the system may have a defect.
(c) If there is air leakage, tighten the nut to 4.0 N*m (41 kgf*cm, 35 in.*lbf) and push the valve core 2 or 3 times to remove any dirt attached to the valve core. If there is still air leakage, replace the grommet, the washer and the nut all together.
(d) When installing the tire pressure warning valve and transmitter, check whether the rim, grommet, washer and nut are clean. Use a manufacturer-specified cap.
(e) When putting air into the tire, first install the tire pressure valve straight onto the stem of the tire pressure warning valve and transmitter.
2. TIRE AND WHEEL REPLACEMENT OR TIRE ROTATION
(a) When replacing the tires, be sure to check if the grommet of the tire valve is damaged. If so, replace the grommet together with the washer and nut.
(b) When the tires and wheels are replaced, make sure to register the transmitter ID.
NOTICE:
Transmitter IDs of all tires including the spare on the vehicle should correspond to IDs registered in the ECU.
Parts Location
PARTS LOCATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
...
Poor Sound Quality in All Modes (Low Volume)
PROCEDURE
1.
CHECK AUDIO SETTINGS
(a) Set Treble, Mid and Bass to the initial values and check that sound is normal.
OK:
Malfunction disappears.
HINT:
Sound quality adjustment measures vary according to the type of amplifier.
OK
END
...
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK FOR DTC
HINT:
When using the Techstream with the engine switch off to troubleshoot:
Connect the Techstream to the DLC3 and turn a courtesy light switch on and off
at 1.5-second intervals until communication between the Techstream and vehicle begins.
(a) Connect the ...