Toyota Tacoma (2015-2018) Service Manual: Dtc Check / Clear

Toyota Tacoma (2015-2018) Service Manual / Door Lock / Wireless Door Lock Control System(w/ Smart Key System) / Dtc Check / Clear

DTC CHECK / CLEAR

1. CHECK FOR DTC

HINT:

When using the Techstream with the engine switch off to troubleshoot:

Connect the Techstream to the DLC3 and turn a courtesy light switch on and off at 1.5-second intervals until communication between the Techstream and vehicle begins.

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(d) Enter the following menus: Body Electrical / Smart Key / Trouble Codes.

(e) Read the DTCs.

2. CLEAR DTC

HINT:

When using the Techstream with the engine switch off to troubleshoot:

Connect the Techstream to the DLC3 and turn a courtesy light switch on and off at 1.5-second intervals until communication between the Techstream and vehicle begins.

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(d) Enter the following menus: Body Electrical / Smart Key / Trouble Codes.

(e) Clear the DTCs.

Diagnosis System

DIAGNOSIS SYSTEM 1. DESCRIPTION The ECU stores trouble codes when malfunctions occur. The diagnostic system allows for reading of the trouble codes from the DLC3. Use the Techstream to help diagno ...

Terminals Of Ecu

TERMINALS OF ECU 1. CHECK DRIVER SIDE JUNCTION BLOCK AND MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (a) Disconnect the MB main body ECU (multiplex network body ECU) connectors. (b) Measure the ...

Other materials:

Removal
REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure listed below is for the LH side. PROCEDURE 1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (See page ) 2. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG (See page ) 3. ...

FCM Destination Information Unmatched (C1AA1)
DESCRIPTION When the forward recognition camera is replaced with a new one, the new forward recognition camera attempts to store country specification information received from the main body ECU (multiplex network body ECU) and ECM. If the country specification information stored in the forwa ...

Front Upper Suspension Arm
Components COMPONENTS ILLUSTRATION Disassembly DISASSEMBLY PROCEDURE 1. REMOVE FRONT SUSPENSION UPPER ARM BUSH (a) Using a hammer and chisel, raise the flange of the bushing diagonally as shown in the illustration. (b) Using SST and a press, remove the front suspension u ...